User manual CANTON DIGITAL MOVIE 8

[. . . ] Welcome to the world of pure music We are delighted that you have chosen a Canton loudspeaker. Our products combine high quality components with many years of development experience and meticulous production methods. [. . . ] There are various ways of connecting the Canton Digital Movie System depending on the type and configuration of your television or audio sources. To transmit the DVD audio signal connect the audio outputs of your DVD player to the inputs of the DM System marked "DVD". To transmit the visual signal your DVD player must also be connected to your television. The input of the DM System marked "AuX" can be used to connect a SAT receiver, video recorder or games console. output To connect an external subwoofer use the output of the DM System marked "SuB OuT". Note When connecting please be sure to connect the left and right channels correctly. Power On ­ Display shines blue Standby ­ leD shines red Mute Input Volume Play Mode Stereo ­ for music Surround ­ virtual surround sound for home cinema Sound Mode loudness ­ increase in bass and treble Voice ­ bass and treble reduction Bypass ­ linear sound The DM system has a multifunctional display that lights up blue for approx. If you have any further questions please contact your Canton dealer, call our Service Hotline on +49 (0) 6083 / 287 57 or send us an e-mail at info@canton. The power has not been turned on Sound reproduction too soft DM system does not respond to remote control DM system hums Signal line from amplifier to DM system too long 2. Signal line used is not fault-protected or the protection has been damaged (defective) 3. Use shorter signal line Change signal line for a fault-protected line A ground loop can be generated when two or more devices connected via a signal line (cinch) are plugged into separate sockets (e. All devices connected to the amplifier should be plugged into the same multiple socket outlet Switch off possible sources of interference to test; unplug the device concerned to see if the humming noise disappears or connect the source of interference to a different circuit (l1, l2 or l3). [. . . ] This applies to all loudspeakers purchased from an authorised Canton dealer. In the event of damage please contact your dealer or the Canton Service department direct. [. . . ]