User manual CANTON DIGITAL MOVIE DM 70

[. . . ] The DM 70 has magnetic shielding and can therefore be positioned next to your television set. Do not position your DM system near any heat source or open flames (e. For safety reasons always unplug the DM system from the mains during long periods of disuse or in case of thunderstorms or possible flooding. Do not place anything on the cabinet of the DM system or in front of the bass reflex opening. [. . . ] The video signal connections are made directly between the audio source devices and the image playback device. The required input must be selected using the slide switch (OPT/COAX) on the rear of the DM 70. The Sub Out can be used for the connection of an optional available active subwoofer. note: When connecting an active subwoofer to the DM 70 go to , , Speaker Setup" and set the volume of the subwoofer at -6 dB. Please put the remote control with the keypad facing down on an even surface and remove the cover on the back of the remote control. Be careful to ensure that it is inserted correctly according to the polarity markings (+/-). In order to avoid unloading, the battery should only be touched on the , , +" pole. When all the devices are connected and the system is plugged in at the mains the Canton DM system is in standby mode. If the remote control is not used for more than 30 seconds it returns to standby mode and can be reactivated by pressing any button. The DM system can be switched on or returned to standby mode by pressing . If the red power light (LED) is flashing this means that there is no wireless connection between the remote control and the system. By pressing the volume of the DM system in the main menu can be adjusted in 100 stages from 0 . The following lights will come on: - one volume LED - one playback mode LED - one or two decoder mode LEDs Press again to turn the DM system off. You can switch the inputs of the DM system directly using the buttons , , sat", , , dvd", , , tv" and , , aux". Use to select whether the sound reproduction should be in stereo or surround mode. Note: In order to accommodate the different recording philosophies unique to music recordings we have implemented two surround modes. Use , , surround 2" predominantly in the case of poor speech intelligibility (for example, when the speech reproduction seems unusually dull and unclear). Once your DM system has been successfully connected you need to adjust the individual components to suit the enviroment. To adjust the DM system, turn it on and press the button for about 3 seconds. You can then use the relevant buttons (spk level, spk delay, bass exp. The values within each function can be adjusted up or down using the ­setup+ buttons. To leave the Setup press one of the input buttons, press the button again or wait until the remote control goes into standby after approx. [. . . ] The levels for the bass are set too low Sound is too tinny You have too little upper bass You have too much upper bass Bass are set too high 2. The DM is very close to the wall or in the corner Reposition the DM further away from the wall 1. You have too much lower bass The DM is very close to the wall or in the corner 2. Your bass levels are incorrectly set You have a delay between the image signal of your flat screen and the audio signal The signal sounds distorted The signal processing of the flat screen takes longer than that of the DM system The level of the system is set too high 40 To ensure that you enjoy your Canton loudspeakers for a very long time please note the following care and maintenance instructions: Do not expose the cabinet of the loudspeaker to direct sunlight. [. . . ]