User manual CANTON COMBI

[. . . ] , unnatural, intermittent "rapping" or "hammering" sounds) coming from this unit, reduce the volume level. Do not attempt to clean this loudspeaker with chemical solvents as this might damage the finish. Strong fluctuations in temperature may lead to condensation (water droplets) forming inside the subwoofer. Canton shall not be liable for any accident caused by improper placement or installation of speakers. [. . . ] These wall brackets always belong to the scope of supply of your sub-sat system. You can buy the Canton LS-speaker stands as an accessory from your nearest Canton dealer. You will find the connector terminal as shown left on the rear of your Canton speakers. These terminals are provided for connecting the Canton speakers to the amplifier. If present, first remove the insulating protective caps from the screw terminals. In order to make it easier to distinguish plus (+) from minus (-) the clamps on the back of the loudspeaker (plus = red, minus = black) as well as the screwclamps of your amplifier or receiver differ in colour or are marked with a symbol. also the two conductors of the loudspeaker cable differ in colour , form or marking. Different polarity between the left and the right or the front and the surround channel lead to sound falsifications. For a better understanding please check the operating instructions of your controller. Screw terminals: For connections to the loudspeaker outputs on your amplifier, the Canton active subwoofer is fitted with two sets of screw terminals marked HIGH LEVEL INPUT (fig. When connecting, please note the correct layout of the left and right ports and the polarity of the terminals (red = plus / black = minus). If the polarity is accidentally reversed, the sound from the subwoofer will be unnatural with poor bass. RCA sockets: The Cinch inputs on your subwoofer are marked LOW LEVEL INPUT and are designed for connection to a preamplifier output or a special subwoofer output (LFE) on your control unit (fig. To cut the power, switch the subwoofer off using the power switch (fig. amplifier Mode: When the power switch is set to "ON" , the Amplifier Mode switch (fig. In the "AUTO" position, the subwoofer automatically switches itself on when a musical signal is detected. In the absence of any musical signal your subwoofer automatically (approx. In order to protect the main amp of your subwoofer against a possible overloading it was equipped with a fuse (fig. Please make sure when changing the fuse that the power of the main amp is disconnected. In addition it is to be made certain that only fuses are used which correspond to the given values (0. [. . . ] If the signal level of the subwoofer output cannot be increased any more, instead reduce the signal levels of the other outputs by the same amount each !1 Are the signal lines from the amplifier to the subwoofer longer than necessary ?2 Is your signal line not shielded, or is the shield of your line interrupted (defective) ?A ground loop can result when two or more devices connected via signal lines (Cinch) are connected to mains power outlets with mains grounding contact in different places (e. [. . . ]