User manual CANTON CD 3500 WIRELESS

[. . . ] To avoid damage from lightening strikes, the mains plug should also be unplugged when thunderstorms are expected. When using an audio source with fixed output, this default level should be reduced by using the volume push button (-) to avoid physically damaging the unit. When connecting the loudspeaker via the High or Low-Level input, the volume level must be adjusted using the audio source. Directly connecting a source with fixed output can lead to full conduction of the in-built power amplifiers and creates extreme sound levels which may damage your health. [. . . ] The transceiver can then be connected to the mains power supply and your control unit can be switched on. As well as checking the correct channel connections, make sure the cabling polarity is correct. To avoid shortcircuiting, the stripped ends of the loudspeaker cables should be as short as possible, not protrude out of the screw terminals and under no circumstances should they be touching. The only cabling for both CD 3500 wireless loudspeakers involves mains connection. Introducing a music signal will activate the system out of standby mode. This allows you to regulate the sound level evenly for the left and right channels. As a basic principle for audio sources with variable output, the sound level should preferably be set high and the reproduction sound levels should be regulated via the remote control. the infrared sensors for receiving the remote control signal are located in the transceiver and in the loudspeakers. This means that the sound can be controlled by remote control even when the speakers are placed in an adjoining room without line of sight to the transceiver. When the system is switched off, the most recent volume settings are retained. Setting the sensitivity of the transceiver depends on the audio source that is being used. 16) on the back of the transceiver can be used to align the sensitivity of the transmitter module to the volume level of your control unit. Settings between P 1 and P 3 are available whereby P 1 is the highest level of sensitivity. If the selected input sensitivity is too high, the transceiver becomes overloaded, the sound from the loudspeakers is distorted and the LEDs of the function indicator (Fig. When the correct input sensitivity has been chosen, the LEDs on the function display glow green or briefly flash orange at extreme levels. For example, if P 1 is the switch setting on the transceiver, then P 1 must also be selected on the loudspeakers. The CD 3500 wireless can be connected like a normal active loudspeaker directly via an appropriate cable by using the screw terminals (Fig. Adjusting the volume level is done via the variable output on your control unit and NOT via the enclosed wireless system remote control. 4) on the terminal of the loudspeakers may be used to connect an additional active sound source e. The sound level from this output is simultaneously adjusted to the volume of the CD 3500 wireless and also via the enclosed remote control. The principle of the CD 3500 wireless allows simultaneous operation of up to three systems, therefore 6 loudspeakers and 3 transceivers. To enable this, differing transmission lines must be chosen for the second and third systems. [. . . ] LEDs on transceiver not lit LEDs on the loudspeakers not lit No sound signal, LEDs on transceiver permanently red - Check plug and/or mains connection. No sound signal, LEDs on transceiver flash green No sound signal, LEDs on transceiver glow permanently green System switches off during quiet music Sound signal distorted, LEDs on transceiver glow orange 3" Brushed aluminum silver up to 25 meters in closed environments max. WARRANTY Canton provides a 5 year warranty against factory defects for all passive loudspeakers. There is a 2 year warranty against factory defects for active subwoofers and semi-active speakers. [. . . ]