User manual CANNON FITZROYIN-BUILT POWERFLUE

[. . . ] Any product subjected to misuse, abuse, negligence, accident or alteration will have its warranty voided. If installation is not carried out in accordance with manufacturer's instructions, this warranty may be void. The customer must keep their "Tax Invoice" as proof of purchase of this product, and compliance certificate as proof of required installation. Model number: ______________________________________ Serial number: _______________________________________ Date of manufacture: _________________________________ Date installed: _______________________________________ Compliance Certificate No: ____________________________ Don't risk your appliance warranty Only a licensed person will give you a Compliance Certificate, showing that the work complies with all the relevant standards. [. . . ] Ensure the minimum clearances to combustible construction are maintained during installation, including adequate space for the proper operation and servicing of the heater. For clearances to curtains and furnishing refer to warning 3 & 4 on page 4. Refer to the data label located on fan chamber base, rear of pedestal front. Prepare electrical and gas connections, a 10 Amp wall socket needs to be located within 1. 5m of the heater. Refer to gas connection instructions on page 12 and flue installation instructions on pages 16 & 17). 10 8. 10. Remove the heater front by pulling it towards you gently to partly disengage it from the body of the heater then gently lift it up vertically to completely disengage it. Connect incoming gas supply pipe to 1/2" compression fitting at rear of appliance. Logs are numbered as follows: No 1 - Left front log No 2 - Left back log No 3 - Right front log No 4 - Right back log Position the four individually numbered logs in the following order on the burner head as shown in figures 17-20. The male locating pins in the burner head must engage with corresponding holes in the individual logs. a) Place log No. 1 onto the 2 front left pins on the burner head, ensuring that the charring faces the front. Refer figure 18. 18 c) Place log No. 3 on single right front pin, ensure fork locates over log No. Part no: BOXFB. 26 Flue kit The flue kit contains: 2 x 900mm lengths of 125mm ø painted upper flue 1 x 900mm painted bottom flue spigot 1 x 900mm length of 125mm ø plain flue 1 x ceiling ring 1 x 125mm AGA approved gas cowl 16 27 17 Service instructions. Unplug from wall socket or turn off power at main switchboard if heater is hard wired. Always shut off the gas supply and ensure that the heater is cool before commencing any service operations. Always check for gas soundness after servicing. To replace the primary glass 1. 2 Refit glass and replace in reverse order ensuri the inside surface of the glass is clean and free from finger marks. To replace the outer glass 1. Support the bottom of the glass and remove the two lower glass retaining posts. Refit glass in reverse order ensuring the inside surface of the glass is clean and free of finger marks. Note: ensure the inside surface of the glass is clean and free from finger marks. To replace the gas control 1. The blue module (ignition device) needs to be removed to allow removal of the gas control. Remove screw from front of rectifier lead located below domed cap on gas control. Unplug polarise plug (wires feeding to module and gas control) and remove spark/sense electrode connections, earth connection from module and earth connection form gas control. [. . . ] To reset the module turn off the power supply for 10 seconds and then turn the power on again. · Check the internal 2-A fuse in the loom. 3. After resetting the module and appliance is still not operating. and still appliance not operating 4. · Check other connections are in place. · If the last checks are correct the ignition electrode should spark at the same time as the gas control solenoid valves open. [. . . ]