User manual CANNON FITZROYIN-BUILT MOCK

[. . . ] * At the owner's discretion curtain clearance can be less than 900mm as long as they are restrained from the front, top and sides of the heater. The manufacturer takes no responsibility if curtain clearance is less than 900mm and not restrained. Children and adults should be alerted to the hazard of high surface temperature and should take care to avoid burns or clothing ignition. Young children should be carefully supervised when they are in the same room as the heater. [. . . ] More frequent cleaning may be required due to excessive lint build-up from carpeting, bedding materials, pet hair, etc. It is imperative that control compartments, burners and circulating air passage ways of the appliance be kept clean. Do not use this fire if the glass is cracked or with the glass safety screen removed. Do not use fire with broken or missing logs. 8 Heater Specifications Gas type: Gas consumption: Energy star rating: Energy output: Heater type: Operating pressure: Min. inlet pressure: Natural or Propane gas, as indicated on data label 26 MJ/hr input 3. 77 20. 7 MJ/hr Heater approved to AG 103. Natural gas: 1. 0 kPa Propane gas: 2. 65 kPa 1. 20 kPa (NG) For Propane gas regulated to supply 2. 65 kPa Integral with controller Three speed Electronic 240 VAC 10 A · Safety guard · Gold or silver trim · Glass front · Cathedral ceiling flue box 3 x 900mm lengths of 125mm ø painted flue. 8. Gas regulator: Fan: Controller: Power requirement: Optional Accessories: Flue kit: Overall dimensions: 8 9 Installation Instructions 1. This appliance is to be installed in accordance with the manufacturer's installation instructions, AS 5601/AG 601, Municipal Building Codes, Electrical Wiring Regulations and any other statutory regulations. Clearances 3. Ensure the minimum clearances to combustible construction are maintained during installation, including adequate space for the proper operation and servicing of the heater. For clearances to curtains and furnishing refer to warning 3 on page 4. Check that the heater is suitable for the gas available (Please dispose of packaging appropriately, keep away from children). On Natural Gas the gas pressure must be set at 1. 0 kPa. 15 Flue installation This heater is a flued appliance. It must be properly connected to a flue system in accordance with the latest edition of the Gas Installation Code, AS 5601/AG 601. If elbows are needed, the total horizontal length depends on the number of elbows used. If practical locate the heater in a position to minimise the use of horizontals and elbows. The flue rise should be a minimum of 1. 8m before any horizontal run is used. If placed against a combustible wall the 40mm rear spacers locate against the wall. The centre line of the flue is 120mm to rear of appliance (including rear spacers). Carry out installation as per figure 26 (ceiling plate installation) and figure 27 (flue installation). Cut a hole 180mm ø in the ceiling in line with the flue position. Secure ceiling plate against the ceiling by bending out the tabs above the ceiling. Note: If the ceiling has an incline, the ceiling box will need to be fitted. [. . . ] · Check that the gas pressure is present at the test point when the spark is being generated. Connect a multimeter in series with the flame rod and set the function to measure micro-amps. The module will go into lockout if the flame current sensitivity is less than 0. 5 micro-amps. The approximate signal strength on high flame is about 10 micro-amps and on low 4 micro-amps. [. . . ]