User manual CANNON CANTERBURY IN-BUILT MOCK

[. . . ] * At the owner's discretion curtain clearance can be less than 900mm as long as they are restrained from the front, top and sides of the heater. The manufacturer takes no responsibility if curtain clearance is less than 900mm and not restrained. Children and adults should be alerted to the hazard of high surface temperature and should take care to avoid burns or clothing ignition. Young children should be carefully supervised when they are in the same room as the heater. [. . . ] A safety guard conforming to AGA requirements is available for this heater. It is an optional extra, which may be fitted to the heater to reduce the risk of fire or injury from burns. For permanent protection of young children or the infirm, an optional mesh guard is recommended. Call your retailer or authorised service agent for further details. Standards This appliance meets the following standards: Standards Australia: AS 3100 AS 5601/AG 601 AS 4553/AG 103 5 User instructions Operating instructions The Australian Gas Association: AG 103 1. Plug the power cord into the wall socket and turn on the power to the heater, see figure 1. On low burner setting it is more efficient to operate the fan speed on LOW. 7 8. If the burner fails to ignite, wait 20 seconds and repeat the ignition porcedure. To turn burner OFF To turn burner ON 7 User instructions continued Cleaning. All cleaning should be carried out when the heater is cold. Normally the heater should only need wiping with a lint - free damp cloth. Any stubborn stains can be removed with a non-abrasive spray on cleaner. Internally the heater should only be cleaned by a licensed service person listed in this manual. The outlet pressure point is situated on the RHS top of the gas control. Important: To achieve the correct visual flame effect: On Propane the gas pressure must be set at 2. 75 kPa with burner operating on maximum setting. On Natural Gas the gas pressure must be set at 1. 0 kPa. 13 Flue installation This heater is a flued appliance. It must be properly connected to a flue system in accordance with the latest edition of the Gas Installation Code, AS 5601/AG 601. If elbows are needed, the total horizontal length depends on the number of elbows used. If practical locate the heater in a position to minimise the use of horizontals and elbows. The flue rise should be a minimum of 1. 8m before any horizontal run is used. If placed against a combustible wall the 40mm rear spacers locate against the wall. The centre line of the flue is 75mm to rear of appliance (ex cluding rear spacers). Carry out installation as per figure 23 (ceiling plate installation) and figure 24 (flue installation). Cut a hole 180mm ø in the ceiling in line with the flue position. [. . . ] If practical locate the heater in a position to minimise the use of horizontals and elbows. The flue rise should be a minimum of 1. 8m before any horizontal run is used. Carry out installation as per figure 25 (ceiling plate installation) and figures 27 & 28 (flue installation). One large and two small holes in the bottom end of the lower outer flue cover locate around the flue spigot and two locating pins. [. . . ]