User manual CANNON CANTERBURY FREESTANDER

[. . . ] Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to other sections of this manual for correct procedures, or consult with place of purchase, a licensed plumber, a gas supplier or service agent listed in this manual. Due to high temperatures the room heater should be located out of traffic and away from: · · · Furniture and draperies, Combustible materials, Gasoline and other flammable liquids, Do not place clothing or other flammable material on or near the heater. Keep curtains*, clothing, furniture and other flammable materials at least 900mm from front, rear and sides of the heater. [. . . ] More frequent cleaning may be required due to excessive lint build-up from carpeting, bedding materials, pet hair, etc. It is imperative that control compartments, burners and circulating air passage ways of the appliance be kept clean. Do not use this fire if the glass is cracked or with the glass safety screen removed. Do not use fire with broken or missing logs. 8 Installation Instructions 1. This appliance is to be installed in accordance with the manufacturer's installation instructions, AS 5601/AG601, Municipal Building Codes, Electrical Wiring Regulations and any other statutory regulations. Clearances 3. Ensure the minimum clearances to combustible construction are maintained during installation, including adequate space for the proper operation and servicing of the heater. For clearances to curtains and furnishing refer to warning 3 on page 4 For minimum clearances refer fig 9 and 10. 9 10 Installation 4. Prepare electrical and gas connections, a 10 Amp wall socket needs to be located within 1. 5m of the heater. Refer to gas connection instructions on page 11 and flue installation instructions on pages 14 & 15 and 16 & 17). Remove the front glass surround by holding it firmly on either side and pulling it towards yourself, see figure 13. 13 10. Remove the inner glass. Connect incoming gas supply pipe to compression fitting at rear of appliance. For inlet position see figure 15. 15 11 Installation instructions continued Fuel bed and log installation 12. The fuel bed is retained by a spring clip fixed to the rear of the burner chamber FUEL BED MUST BE HARD UP AGAINST REAR OF BURNER 16 13. Logs are numbered as follows: No 1 - Left front log No 2 - left back log No 3 - Right front log No 4 - Right back log Position the four individually numbered logs in the following order on the fuel bed as shown in figures 17-20. The male locating pins in fuel bed must engage with corresponding holes in the individual logs. a) Place log No. 1 onto the 2 front left pins on the fuel bed, see figure 17. 17 b) Place log No. 2 onto the 2 left back pins. Refer figure 18. 18 c) Place log No. 3 on single right front pin, ensure fork locates over log No. 4 on single right back pin, ensure left side of log rests on depression in No. [. . . ] Remove the four M5 screws fixing the burner chamber fascia in position and slide out taking a note of the "P" clip position through which the thermocouple leads are passed. Remove the two M5 screws fixing the burner to the burner chamber fascia. Remove the two 8G self tapping screws fixing the electrodes in position. Replace in reverse order. Troubleshooting Item No 1 2 Check Check 240V power to heater. [. . . ]