User manual CAMPINGAZ IR 5000 TURBO

[. . . ] Switzerland, Germany, Austria: This appliance must be used with a DIN hose the quality of which shall comply with the use of butane or propane gas. Connecting the hose: to connect the hose to appliance inlet union, firmly but moderately tighten the hose using 2 suitable spanners: - 14 mm spanner to tighten appliance inlet union. Il must be used with a hose the quality of which shall comply with the use of butane or propane gas and with the national regulations in force (BS, UNI, UNE, etc. [. . . ] 3- Fully press several times the LH button marked with a stylised star ()(B) for lighting up the flame, while holding control button (A) depressed for 10 seconds. The thermocouple is activated and the safety valve does not cut off gas feed. Release control button (A) 4- Check whether the appliance did light up. This will prevent the appliance from lighting up during the first attempt. In this case, it is necessary to repeat the ignition procedure several times until the safety pilot burner lights up. During appliance operation, the safety pilot burner must remain permanently lit in order to ensure correct operation of the atmosphere analyser. During the first setting to service, operate the appliance at maximum power for at least 15 minutes in order to eliminate the typical new appliance smell due to the presence of protecting substances applied to the component parts. 5): Your appliance is equipped with a setting handle which makes it possible to adjust the temperature radiated by the infrared panel depending on the temperature desired in the room. A) IR 5000 and IR 5000 Turbo Versions - Adjust the power by placing the mark on the lever between ( ) and ( ) (3 positions, see Fig. 5 - IR 5000 - and - IR 5000 Turbo - reference A) b) Exclusive to IR 5000 Turbo Version After lighting up your appliance in compliance with the indications of paragraph E-1, you can increase its heating performance by means of the "Turbo" function. The "Turbo" function provides for fast and even heating of the room because it uses a tangential ventilation to propel the hot air flow out of the appliance. The "Turbo" function is turned on / off by pressing the red button (fig. Your installation must be equipped with a grounding connection compliant with electrical systems specifications in force. E - 3 - SHUTTING DOWN THE APPLIANCE: - close bottle cock and/or gas pressure reducing valve handle. D - 2 - Tightness: In case of leak, appliance gas supply must be shut down using gas bottle cock and/or pressure reducing valve handle. Do not carry out leak tests with a flame, use a gas leak detecting liquid. The appliance should not be returned to service until the leak is removed. Important: In case of gas leak or odour, immediately close bottle cock and/or pressure reducing valve handle. [. . . ] - Poor gas feed - Pressure reducing valve inoperative - Check for gas level in bottle - Check for gas level in bottle - Check hose connection - Call technical support - New bottle. Allow to operate, the defect will disappear - Call technical support - Pilot burner clogged - Call technical support. The burner misfires or turns off Unstable blowing flames The pilot burner does not light up WARRANTY APPLICATION TERMS AND CONDITIONS The product is covered by a total parts and labour warranty for 2 years with effect from the purchase date, excluding return transport charges that should be borne by the consumer. [. . . ]