User manual CAMPINGAZ CHALUGAZ

[. . . ] Refer to the handbook to familiarise yourself with the appliance before connecting the gas bottle. This appliance must be connected using a pressure reducing valve and a hose. Non conformance with these instructions may be dangerous for the user and his environment. Permanently keep this handbook in a safe place so as to refer to it when needed. [. . . ] The appliance should not be installed in a room the volume of which is less than 82 m3 for living-rooms and 41 m3 for other rooms. Air renewal ventilation area should not be less than 103 cm² evenly distributed between room upper and lower levels. A safety device will shut off the gas, thus extinguishing the appliance if normal ventilation conditions are not met. C - 2 - Gas bottle and pressure reducing valve: This appliance is designed to operate with 11 Kg to 15 Kg Butane or Propane gas bottles fitted with an adequate pressure reducing valve (See Gas and operating pressures page 3). In France, it is strictly forbidden to use another gas type than Butane. If an empty bottle is in place, read paragraph F"Removing or replacing gas bottle". To install or remove a gas bottle, always operate in a well-ventilated place and never in presence of a flame, spark or heat source (cigarette, electric appliance, etc. Note: if the appliance is new, loosen screws (4) by a quarter turn, lift and remove rear plate (3). D - 1 - Installing gas bottle: - Position the gas bottle on the floor behind the appliance. - Check whether bottle cock and/or pressure reducing valve handle is in "closed" position. - Screw in or engage pressure reducing valve to gas bottle or gas bottle cock (fig. OPERATING PRECAUTIONS: DO NOT install the appliance next to a wall, curtains or a sofa or armchair. This appliance protecting grid is designed to prevent fire hazards or burns and no part shall be permanently removed. E - 1 - IGNITING THE APPLIANCE: Note: Gas opening and closing controls are located on gas bottle and/or on pressure reducing valve. IThe ignition spark, gas inlet control and power control are operated on the control panel located in the top right-hand corner of the appliance. 5 items A, B and C) 1- Open bottle cock and/or pressure reducing valve handle and carry out a leak test. Your installation must be equipped with a grounding connection compliant with electrical systems specifications in force. - Check that gas bottle cock and/or pressure reducing valve handle is in the closed position. 4 item B) and remove the bottle from its housing, taking care not to pull or bend the hose. - Install the new gas bottle and carry out a leak test as described under paragraphs D-1 and D-2. G - STORAGE - SERVICING 1) Appliance When it is not used, the appliance should remain open and be stored in a dust-free place. - The appliance must be periodically checked, more particularly concerning condition of the connecting hose. [. . . ] - The hose must be replaced in compliance with the above-mentioned periodicity for the respective countries. - In France, if the expiry date printed on the hose is reached, it must be replaced by a hose compliant with the XP D 36-112 Standard. - Comply with installation indications provided with these new assemblies to be 0. - If your appliance is to remain unused for a long period, disconnect gas bottle. [. . . ]