User manual CAME ZM2

[. . . ] When the burners are not being used the mains gas supply valve should be closed. To save gas, make sure that the flames do not overlap the bottom of the pan. THE CHOICE OF BURNER : The hob is fitted with burners of different sizes and heat ratings. It is important to know how to make use of resulting differences in power. [. . . ] HOW TO OPERATE THE SURFACE UNIT : --------------------------------------------------------------• Locate the sign corresponding to the surface unit radiant hilight front left (only VM 41 model) 18 - • Turn the control knob until the required cooking position is set. It is recommended to heat the pan on "high" level until properly warmed up and then lower to desired cooking setting. € The residual heat indicator lights up when the surface unit temperature is 60°C and above. It will stay on, even if the unit is switched off, until the surface has cooled down. It will switch off when the temperature of the surface falls below 60°C. • The power-on indicator light comes on and stays on throughout cooking. THE DIFFERENT POWER LEVEL SETTINGS -----------------------------------------------------------------0 Stop 1-2 3-4 5-6 7-8 Very slow Slow Moderate Medium To keep a dish hot, melt butter and chocolate . 9 - 10 High 11 - 12 Very high RECOMMENDATIONS FOR COOKING WITH A VITROCERAMIC COOKTOP ___________________________________________________________________________________ To obtain the maximum performance from your appliance it is absolutely essential to take certain precautions or respect certain conditions. For example : • Always use good quality cookware with perfectly flat bottoms : using cookware with perfectly flat bottoms will prevent hot spots that cause foods to stick. € Ensure that the base of the pot or pan is dry : make sure that cookware bottoms are dry. If you want to take the knobs off for a full cleaning, take care not to let water go into the open zone, and then check carefully that you completely re-seat the control knob. Using a razor scraper will not damage the surface if the 30° angle is maintained. ___________________________________________________________________________ INSTALLATION - BUILT-IN ___________________________________________________________________________________ The cabinet in which your hob will be installed and all adjacent furniture, should be made of materials which can withstand temperatures of up 100°C. In addition, all decorative laminates must be fixed with the heat-resistant glue. Take care to keep a minimum 5 cm between the appliance and adjacent furniture. To ensure proper ventilation around the hob, allow at least 1 cm between the underside of the hob and the cabinet, and a 10 x 10 cm opening as illustrated. When placing the hob, make sure that the joint (fiited with the hob) between the surrounding edge of the appliance and the worktop is properly sealed and that spillages cannot leak into any gap. 6 10 x 10 cm opening for supply cable and ventilation - 21 ___________________________________________________________________________ INSTALLATION - GAS CONNECTION ___________________________________________________________________________________ These technical instructions are specially for the installers. This appliance is not connected to an evacuation system for residual products. The airflow necessary to the combustion must be 2 m3/h by kW of power. [. . . ] Attention : always check the continuity of the connection to the installation before any electrical operation. Rosières cannot be held responsible for any accidents resulting from the use of an appliance which is not connected to earth, or as a faulty earth connection continuity. For any matter relative to the supply cord, ask for After sales service or for a qualified technician. ___________________________________________________________________________ GUARANTEE ___________________________________________________________________________________ The guarantee contract consists simply and solely in exchanging or replacing any part considered by us to be defective, or repairing it after examination by our Technical Assistance, to the exclusion of all other indemnities of whatever kind. [. . . ]