User manual CAME ZL90

[. . . ] X = minimum 150 mm Z = 10 mm Y = partition Fixing the cook top to the unit The cook top is fixed to the unit by means of the brackets and accessories provided. Holes are provided in the bottom of the tray where the tabs (A) are inserted so that you can attach the screws (C) that hold the brackets (B) in place. A = tab for inserting in the bottom of the cook top tray B = fixing bracket C = screw 12 Applying the seal Important - The figure below shows how the seal must be attached all around the perimeter. [. . . ] For models without a plug, fit a standard plug capable of withstanding the specified load on the power cord. If you prefer to make a fixed connection to the mains, insert an all-pole circuit breaker with a breaking gap of at least 3 mm between the cook top and the mains. To connect the cook top power cord, loosen and remove the cover on the terminal block in order to access the contacts inside. Make the connection, blocking the cord in place with the cable clamp provided and then close the terminal block cover again immediately. If you have to change the cord, the earthing (yellow / green) conductor must always be 10 mm longer than the line conductors. Use only rubber cable type H05RR-F; the cross-section of the wires must be 3x1. In the parts destined to come into contact with foodstuffs, this appliance is in accordance with the requirements of the EC directive 89/109 transposed in the Italian Legislative Decree N° 108 of 25/01/92. Water can be poured into the container in place of the lava, to a level of at least 3cm. The water prevents unpleasant smells from forming during cooking, without negatively altering the performance of the barbecue. Do not drop hard objects on the glass surfaces as under some conditions they are sensitive to mechanical loads. If the glass-ceramic surface is accidentally broken or cracked, switch the appliance off immediately and contact the Customer Service Department. Ensure that cables and plugs of other domestic appliances inserted in sockets positioned near the barbecue do not come into direct contact with hot cooking surfaces. Do not, under any circumstances, clean the surface using steam cleaning appliances or similar. Even very small residues of food left on the surface will burn the next time the appliance is used. [. . . ] Any remaining water stains which do not disappear using boiling water can be removed using vinegar or lemon, or lime-scale remover. Clean the frame or stainless steel container immediately using a wet cloth if they come into direct contact with one of these acid detergents. Any encrustations which remain on the glass can easily be removed using a shave hook for glass. [. . . ]