User manual CAME ZL19N

[. . . ] Before making the electric connections, check the efficiency of the earthing system. The manufacturer will accept no liability for any personal injury or damage to property deriving from failure to comply with this requirement. For models without a plug, fit a standard plug capable of withstanding the specified load on the power cord. If you prefer to make a fixed connection to the mains, insert an all-pole circuit breaker with a breaking gap of at least 3 mm between the cook top and the mains. [. . . ] Turning on the burner (Fig 8) After touching the on/off key (1), a burner must be selected within 10 seconds as follows: Touch the “Plus” (5) and “minus“ (4) keys for the burner required. Adjust the setting from 1 to 9 by means of the “+” and “-“ keys (5/4). The “+” and “-“ keys have a repeat function: pressing and holding one of these keys induces an increase or decrease in the setting value of one unit. When setting “0” is reached, there will be no further setting changed. If no pan are detected or if an aluminium pan is detected, the power level flashes on the heater display. Bring the setting down to “0” by means of the “-“ key (4). If the cooking zone is “hot” “0” is displayed alternatively with “H” Turning off the burner instantly: 1. If you touch the “+” and “-“ keys (5-4) simultaneously, the burner goes off immediately. If the cooking zone is “hot” “0” is displayed alternatively with “H”. Residual heat indicator (Fig 9) As long as the temperature of the burner remains high enough to cause injury, the display corresponding to the burner shows the “H” symbol (residual heat) alternatively with “0” symbol. This indication only disappears when there is no longer any danger (at 60°C). FAULT CODES MESSAGES CODE DEVICE F–1 Heater temperature sensor (heater) F–2 Heater temperature sensor (heater) F – 3 (on two Power temperature sensor different displays) (induction generator) F – 4 (on two Power temperature sensor different displays) (induction generator) F – 5 (on two Touch control wiring different displays) F – 9 (on two different displays) c 11. Timer (Fig 12) Induction generator Induction generator FAULT Short circuited Open circuited Short circuited Open circuited Loss of communication between Tc and generator Overcurrent Overheating AUTOMATIC ACTION The corresponding heater turns off. The related +/- keys are locked The two corresponding heaters turn off. The related +/- keys are locked The two corresponding heaters turn off. The related +/- keys are locked - 16 The control device can also have an incorporated timer, which can be assigned to one of the cooking zones. The timer display(12) will show “00”, the other displays “t”. (If the timer is selected by the “minus” key (11), the starting time would be “99” - maximum value). Select the required time from 1 to 99 minutes with the keys “+” e “-“ (10/11). Select the required power setting (from 1 to 9) with the keys “+” e “-“ (5/4). The timer will be assigned to that area: Once countdown is complete the area will switch off automatically. Once countdown is complete an acoustic signal will sound for 30”. [. . . ] WARNING: If the surface is cracked, switch off the appliance to avoid the possibility of electric shock. If the glass surface breaks, unplug the device from the mains supply in order to avoid getting an electric shock. The cook top must never be cleaned with steam or other such cleaning devices. It is essential to clean the cook top - once it has cooled down - every time it has been used. [. . . ]