User manual CAME ZL19A

[. . . ] Ask your local retailer for the complete catalogue of Rosières products. Please read this booklet carefully as it provides important guide lines for safe installation, use and maintenance and some useful advise for best results when using your washing machine. Recherche des pannes 15 When contacting Rosières or a Customer Services Centre always refer to the Model, No. 2 3 FR EN FR EN CHAPITRE 1 CHAPTER 1 CHAPITRE 2 CHAPTER 2 NOTES GENERALES A LA LIVRAISON GENERAL POINTS ON DELIVERY GARANTIE GUARANTEE The appliance is supplied with a guarantee certificate which allows free use of the Technical Assistance Service. [. . . ] WARNING: Never stop a washer dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. CHANGING THE SETTINGS AFTER THE PROGRAMMES HAS STARTED (PAUSE) Press and hold the “START/PAUSE” button for about 2 seconds, the flashing lights on the options buttons and time remaining indicator will show that the machine has been paused, adjust as required and press the “START/PAUSE” button again to cancel the flashing lights. If you wish to add or remove items during washing, wait 2 minutes until the safety device unlocks the door. When you have carried out the manoeuvre, close the door, press START button and the appliance will continue working where it left off. CANCELLING THE PROGRAMME To cancel the programme, set the selector to the OFF position. EN DOOR LOCKED INDICATOR The “Door Locked” indicator light is illuminated when the door is fully closed and the machine is ON. When START is pressed on the machine with the door closed the indicator will flash momentarily and then illuminate. A special safety device prevents the door from being opened immediately after the end of the cycle. Wait for 2 minutes after the wash cycle has finished and the Door Locked light has gone out before opening the door. FR EN “DIGITAL” DISPLAY The display’s indicator system allows you to be constantly informed about the status of the machine: 1) WASH TEMPERATURE When a programme is selected the relevant indicator will light up to show the recommended wash temperature. The Temperature button can be used to decrease or increase the temperature of your chosen wash cycle. SPECIAL “FAST SPIN” PROGRAMME Programme “FAST SPIN” carries out a maximum spin (which can be reduced by using the correct button). MIXED AND SYNTHETIC FABRICS The main wash and the rinse gives best results thanks to the rotation rhythms of the drum and to the water levels. This programme allows a complete washing cycle for garments specified as ‘Hand Wash only’ and laundry items made from Silk on the fabric label. The programme has a maximum temperature of 30° and concludes with 3 rinses and no final spin. It is specially designed to wash mixed sportswear fabrics that cannot be washed on hotter programmes and is designed to remove the soil and staining created by participation in sports activities. This programme washes at a cool 30°C, rinses and spins slowly for the best care of your heavily soiled, delicate garments. This programme is particularly suited to slightly dirty cottons and mixed fabrics. Using the Wash Time button on the Rapid cycle will enable you to select either a 14, 30 or 44 minute wash cycle. When selecting the rapid programme, please note that we recommend you use only 20% of the recommended quantities shown on the detergent pack. For information about these programmes please refer to the programmes table. RAPID 59’ A complete express washing and drying cycle lasting only 59'. [. . . ] At the end of the programme the word “END” will appear on the display. Wait for the door lock to be released (about 2 minutes after the programme has finished). Switch off the machine by turning the programme selector on the “OFF” position. The appliance calculates the time to the end of the selected programme based upon a standard loading, during the cycle, the appliance corrects the time to that applicable to the size and composition of the load. [. . . ]