User manual CAME ZL19

[. . . ] H) Young children should be supervised to ensure they do not play with the appliance. I) There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels. L) There is a risk of fire if cleaning is not carried out in accordance with the instructions. This appliance conforms to the European Directive EC/2002/96, Waste Electrical and Electronic Equipment (WEEE). [. . . ] For the various installations use screws and screw anchors suited to the type of wall (e. If the screws and screw anchors are provided with the product, check that they are suitable for the type of wall on which the hood is to be fixed. - 12 - • Fixing the decorative telescopic flue - extractor version: Arrange the electrical power supply within the dimensions of the decorative flue. If your appliance must be installed as an extractor version, make sure an air exhaust hole has been prepared. 3) in such a way that it is in line with your hood and respecting the distance from the ceiling indicated in Fig. Connect the flange C to the air exhaust hole using a connection pipe (Fig. 4), extract the upper flue up to the bracket and fix it with the screws B (Fig. To transform the hood from a ducting version into a filtering version, ask your dealer for the charcoal filters and follow the installation instructions. € Filtering version: Install the hood and the two flues as described in the paragraph for installation of the hood in ducting version. To assemble the filtering flue refer to the instructions contained in the kit. 9): If the appliance version is with LED lamps, the intervention of a specialised technician is necessary to replace them. Clean air: The clean air function allows you to run the appliance for about 10 minutes every hour at the lowest extraction rate level to allow for constant circulation of fresh air. To activate the function, press the “E” button for a few seconds with the motor off. Once the function has been activated, the letter “C” will start flashing on the display. To deactivate the function press the “B+D” buttons together. Carbon filter: Carbon filters are used to purify the air which is released back into the room. The filters are not washable or reusable and must be replaced at least once every four months. Saturation levels of carbon filters depend on the frequency with which the appliance is used, the type of cooking performed and how often the anti-grease filters are cleaned. To activate the filter alarm function, press the “A+E“ buttons together. - To activate the carbon filter alarm, press the “D“ button. an “A” and a “1”will alternate on the display. - To deactivate the carbon filter alarm, press the “B“ button. [. . . ] To reset the function, press the “A” button for a few seconds. € Saturation of Carbon Filters: This function is activated after the appliance has been running for approximately 120 hours. The letter “A” and the current extraction rate level will alternate on the display. To reset the function, press the “A” button for a few seconds. [. . . ]