User manual CAME ZL180

[. . . ] H) Young children should be supervised to ensure they do not play with the appliance. I) There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels. L) There is a risk of fire if cleaning is not carried out in accordance with the instructions. This appliance conforms to the European Directive EC/2002/96, Waste Electrical and Electronic Equipment (WEEE). [. . . ] Pay attention not to insert the screw into the hole marked with an X on the hole template (the screws and expansion plugs must be suitable for the type of wall). 4) and insert the 3 slots onto the 3 screws that are not completely tightened. Drive in the fourth screw X and tighten the remaining 3 to allow definitive blocking of the upper part of structure B. - Take the lower part of the telescopic structure C and insert it into the upper structure B (Fig. - Suction version: Fix the flexible pipe to the prepared air evacuation hole (Fig. - Filtering version: Fix the flexible pipe to the deflector M and fix screw I as indicated in (Fig. - Take the upper chimney piece and fix it to the structure using the 2 screws A (Fig. Join the lower chimney piece with the upper one and fix it carefully using adhesive tape L (Fig. Insert the suction unit inside the structure paying attention that the previously unscrewed screws O, hook into the slots in the lower part as indicated in (Fig. - Fix the air evacuation pipe H (not supplied) onto the connection flange F (Fig. - Remove adhesive tape L and rest the lower chimney piece above the cooker hood (Fig. Timer: This function allows you to set the appliance to run for 15 minutes and then switch off. To activate the function press the “E” button; the decimal point on the display will start to flash. The timer and the intensive function cannot be activated at the same time. To deactivate the function, set the extraction rate level back to “0”. Clean air: The clean air function allows you to run the appliance for about 10 minutes every hour at the lowest extraction rate level to allow for constant circulation of fresh air. To activate the function, press the “E” button for a few seconds with the motor off. Once the function has been activated, the letter “C” will start flashing on the display. To deactivate the function press the “B+D” buttons together. Carbon filter: Carbon filters are used to purify the air which is released back into the room. The filters are not washable or reusable and must be replaced at least once every four months. Saturation levels of carbon filters depend on the frequency with which the appliance is used, the type of cooking perfor- USE AND MAINTENANCE • We recommend that the cooker hood is switched on before any food is cooked. [. . . ] To deactivate this function, press the “A+E“ buttons together with the motor off. C Button = The display shows the extraction rate of the motor and all the functions of the buttons mentioned above. Filter Alarm: • Saturation of Anti-grease Filters: This function is activated after the appliance has been running for approximately 30 hours. The letter “F” and the current extraction rate level will alternate on the display. [. . . ]