User manual CAME ZG6

[. . . ] € Any repair done by an unauthorized person would cancel the warranty. The manufacturer reserves the right to makes changes and alterations to the product without prior notice. The appliance which you have just purchased complies with the terms of European Directive 73/23 EEC relating to safety and low voltage, and with Directive CEM 89/336/EEC regarding electromagnetic compatibily as amended by 93/68/EEC. Air must be able to circulate freely underneath the appliance to ensure correct ventilation. [. . . ] Do not use : Rain water, water from the fridge, water from any evaporator appliance, water produced by a condenser tumble drier, water supplied by your water softener if it indicates that the regenerating salts need replacing (incompatibility with the EMC system) A Choosing your water You can use either tap water or distilled water for irons. Depending upon the limescale level of your tap water and upon your weekly ironing load (average time : 2/3 hours), it can be more economical to use distilled water for irons (not for car batteries). In this case, your cartridge should last up to 1 year (depending on the amount of your ironing and on the quantity of steam you ask for). Remove, shake it for a few seconds and wait for the resultant colour change (approximately 1 minute). 2 or more mauve squares : we advise you to use distilled water for irons. Never fill the reservoir with hot water Never add products containing alcohol or essences (perfume, eau de Cologne, lavender essence…) to the water. REFILLING WITH WATER WHILST IRONING • You can refill the reservoir during ironing. You do not need to unplug the appliance, and can immediately re-commence ironing. THERMOSTAT ADJUSTMENT • Adjust the thermostat of the iron according to the fabric. € To use steam please ensure that the thermostat dial is set within the 2 and 3 dot settings. TO OPERATE - HEATING PROCESS • • • • • Plug the power cable into an earthed socket. To produce steam again, either the anti-scale cartridge must be changed or distilled water must be used. After changing the cartridge, the unit must be turned off and on again in order to recreate normal operating conditions (Wait 30 seconds before the trying to use the iron. ON ANTI-SCALE CARTRIDGE The reference number to order anti-scale cartridges for this irons is 410 057. The anti-scale cartridges are available in blister-pack from your retailer or from your Helpline on 01825 - 768899. MAINTENANCE Substances contained in fabrics such as cleaning product residues and thread particles may eventually stain the iron soleplate. So if necessary, after ironing rub the plate while it is still warm using a good quality cloth (one which does not leave any traces of fluff) or clean it more thoroughly with an iron-cleaning stick. Do not use scouring powders, alkalines (as used with ovens), abrasives or steel wool. Please make sure that the soleplate is kept clean at all times to maintain the iron's ironing efficiency. - Behälter herausziehen und Filterkartusche richtig einsetzen None of the lights are - Power supply problem lit. The machine does - Appliance not plugged in or On/Off button not pressed - Other not heat up. - The reservoir is empty - The reservoir is incorrectly inserted or has not been inserted. [. . . ] - There is no water in the reservoir - The reservoir is incorrectly inserted or has not been inserted. - Other The machine makes a - The anti-scale cartridge has not been inserted clicking noise - A small amount of water is left in the steam generator The water container cannot be inserted. - The anti-scale cartridge is the wrong way round or has not been correctly inserted - Check the plugs and mains - Plug in the appliance and press the On/Off button. - Fill the reservoir - Insert the reservoir and push it fully in - Insert an anti-scale cartridge into the reservoir - Change the anti-scale cartridge. [. . . ]