User manual CAME ZC2C

[. . . ] The hood must NEVER be used as a support surface unless specifically indicated. The premises where the appliance is installed must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose such as discharging exhaust fumes from appliances burning gas or other fuels. [. . . ] If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. ducting version The cooker hood has an upper air duct B1 and an optional rear air duct B2* , for external fumes exit. Select the suitable air duct and apply the flange C supplied, ensure to close the unused hole duct with cap D* supplied if provided. Note: in some models upper hole B1 is supplied closed: Press firmly to detach the detachable part that closes the outlet hole and remove it. Carry out this operation only if you are sure of the type of installation to make. In some models the rear hole duct is not easily accessible, even when the tap (if mounted) is removed, in this case remove the plastic piece E1 or E2 that is blocking the hole duct, by unwinding using pliers and cutter. Check that the filter/suction selector (inside the cooker hood) G is in the suction (A) position. Electrical connection The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area, after installation. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Replacing lightbulbs 40W - Unscrew the damaged light bulb and replace with an incandescent oval light bulb with a maximum of 40W E14. Replacing the halogen bulbs - Access the light compartment – extract the lamp cover by levering it off with a small screwdriver or similar tool. Only use halogen bulbs of 20W max (G4), making sure you do not touch them with your hands. If the lights do not work, make sure that the lamps are fitted properly into their housings before you call for technical assistance. If situated inside the support grill, it may be one of the following types: Paper filter must be replaced once a month or if colouring appears on upper side, in such cases the colouring is evident through the grill openings. Sponge filter should be washed with hot soapy water once a month and replaced every 5 to 6 washes. Metallic filter must be cleaned once a month, with non abrasive detergents, by hand or in dishwasher on low temperature and short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity. [. . . ] P r ile componente cu care am putea intra in contact se pot înc lzi considerabil în momentul în care se folosesc împreun cu aparatura pentru preg tit mâncarea. n ceea ce privesc m surile tehnice i de siguran care trebuie s fie adoptate pentru evacuarea fumurilor este strict necesar s respecta i regulamentele în vigoare i s apela i la autorit ile competente locale. Hota trebuie s fie cur at tot des atât în interior cât i în exterior (CEL PU IN ODAT PE LUN , respectând în mod expresiv toate indica iile redate în instruc iunile de între inere reproduse în acest manual) Nerespectarea normelor de cur are a hotei precum i neînlocuirea sau necur area filtrelor poate crea la riscuri de incendii. [. . . ]