User manual CAME VER KIT

[. . . ] • The Triple consists of three elements , a hob , an oven and a diswasher. For safety reasons under no circumstances should any modifications be carried out to this appliance. Disconnect from the power supply and immediately contact an approved service agent. € There are certain basic safety rules which are valid for any domestic appliance. [. . . ] When the time is up, the timer automatically cuts off the power supply to the oven. Nota : to set a time, turn the control knob clockwise up to the 120 minutes mark and then turn it back to the required time. THE OVEN "Use" VERY IMPORTANT : the oven and the dishwaher cannot be used at the same time. IMPORTANT : always keep small children away from the Triple while it is in use. 49 THE COOKING METHODS • Conventional cooking : the top and bottom heating elements are used together. This method is ideal for all traditional roasting and baking, for sealing red meats, roast beef, leg of lamb, bread, flaky pastry. Preheat the oven for about ten minutes and place the cooking meat in the mid shelf position. Success is guaranteed for mixed grills, kebabs and "gratin dishes". € Rotisserie : using the top-heating element in conjunction with the rotisserie providing the real flavour of a traditional roast. Fit the skewer into the bracket and slide the bracket and skewer on to the second level. The end of the skewer will then be facing the slot in the drive mechanism. Make sure that the spray arm is free to rotate and is not obstructed by cutlery, crockery or pans. 53 If you wish to change or cancel a programme that is running, carry out the following procedure: . Open the door, keeping the Programme selection button "P" pressed in until all 4 indicator lights are flashing. Before starting a new programme, you should check that there is still detergent in the dispenser. WARNING: if the door is opened during the drying phase, an intermittent audible signal is activated to advise that the cycle is not yet completed. When the door is opened the programme selection indicator lights start flashing. - Once the first two LEDs on the left are illuminated without blinking and the audible signal is off, release the button (the audible signal function is active). - Press again the Programme Selection button, the first two LEDs on the left will go off and the other two LEDs will turn on (the audible signal function is deactivated) - An audible signal will confirm that the setting is completed - To set again the audible signal function repeat the whole procedure. Attention - The dishwasher is equipped with an anti-overflow safety device which in the event of anomaly intervenes by evacuating water in excess. Fault Signals If malfunctions or faults occur when a program is running, the LED that corresponds to the selected cycle (2 LEDS for COLD RINSE programme) will blink rapidly and an audible signal will be activated. In this case, turn the dishwasher off by pressing the On / Off button. [. . . ] Place a few drops of a specialist cleaning product on the hob surface. Rub any stubborn stains with a soft cloth or with slightly damp kitchen paper. Wipe with a soft cloth or dry kitchen paper until the surface is clean. Place a few drops of a specialist cleaning product 30˚ on the hob surface. [. . . ]