User manual CAMBRIDGE AUDIO MINX AIRPLAY

[. . . ] User's Manual Your music + our passion ENGLISH Contents Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Limited warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Make sure you register your purchase. Visit: www. cambridge-audio. com/care By registering, you’ll be the first to know about: •Future product releases •Software upgrades • ews, events and exclusive offers plus N competitions! This guide is designed to make installing and using this product as easy as possible. Information in this document has been carefully checked for accuracy at the time of printing; however, Cambridge Audio’s policy is one of continuous improvement, therefore design and specifications are subject to change without prior notice. This document contains proprietary information protected by copyright. [. . . ] Compliance with this directive implies conformity to the following European Norms. • EN 301 489 – General EMC requirements for radio equipment. To determine the type of transmitter, check the identification label on your Cambridge Audio product. Products with the CE marking comply with European Low Voltage (2006/95/EC), Electromagnetic Compatibility (2004/108/EC) and Environmentally-friendly design of Energy-related Products (2009/125/EC) Directives issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European Norms. •  N 60950-1 – Product Safety Products that contain the radio transmitter are E labeled with CE 1588 or CE alert marking and may also carry the CE logo. • 1275/2008 - Implementing EuP Directive for Standby Power Consumption. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 2 . 4GHz operation of this product in the USA is firmware-limited to channels 1 through 11. Modifications The FCC requires the user to be notified that any changes or modifications to this device that are not expressly approved by Cambridge Audio, may void the user’s authority to operate the equipment. Canada-Industry Canada (IC) This Class B digital apparatus complies with Canadian ICES-003 This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e. i. r. p. ) is not more than that necessary for successful communication. 5 ENGLISH Top panel controls 7 1 2 3 4 5 6 1 Internet radio presets 5 Standby/On button We have preloaded Minx Air with 10 of our favourite internet radio stations. Presets 1-5 can be played by pressing the corresponding preset button. To change the assigned stations use the free Minx Air App for Android or Apple devices, see later section. When the Standby button is illuminated red, the system is in its <0. 5W standby state. When the button is illuminated white the unit is on and ready for playback. When the unit is first turned on, it takes approximately 20 seconds to fully power up and become active. 6 Used to pair (connect to) Bluetooth devices so that they can be played back wirelessly. When the pair button is pressed the button will blink blue for approximately 30 seconds. 3 IR Receiver (behind grille) Port/Handle A clear unobstructed line of sight between the remote handset and the IR receiver is required for reliable operation. 7 X Button Stops streaming playback (and returns the unit to the analogue inputs). [. . . ] If you experience problems please contact us immediately via our helpline phone numbers (as stated on the sticker affixed to your Minx Air) or via our website. The following description of the status lights of the Minx Air may be useful for troubleshooting and in any correspondence with us. Standby button Solid Red – The unit is in its low power standby mode. Blinking Red – When coming out of Standby (powering On) the button will blink red for approximately 20 seconds. Solid White – The system is On and ready to play audio WPS LED (next to the WPS button on the rear panel) Solid Green – The unit is connected to a network. [. . . ]