User manual CAMBRIDGE AUDIO ID10

[. . . ] SUCH MODIFICATIONS COULD VOID THE USER AUTHORITY TO OPERATE THE EQUIPMENT. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] This will allow the new components to settle down, the sonic properties will improve over this time. Grounding and polarisation Do not defeat the safety purpose of the polarized or grounding type plug. If the provided plug does not fit your outlet, consult an electrician for replacement of the obsolete outlet. Power sources The unit should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power-supply to your home, consult your product dealer or local Power Company. Power cord protection The unit must be installed in a manner that makes disconnection of the power supply from the mains socket outlet (or appliance connector from the rear of the unit) possible. Where the power supply is used as the disconnect device, the disconnect device shall remain readily operable. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the unit. To prevent hum and noise, do not bundle interconnect leads with the power cord or speaker leads. Overloading Do not overload wall outlets or extension cord as this can result in a risk of fire or electric shock. Overloaded AC outlets, extension cords, frayed power cords, damaged or cracked wire insulation, and broken plugs are dangerous. They may result in a shock or fire hazard. Lightning For added protection during a thunderstorm, or when it is left unattended and unused for long period of time, unplug the unit from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the unit from lightning and power-line surges. Cleaning To clean the unit, wipe its case with a dry, lint-free cloth. Do not use any cleaning fluids containing alcohol, ammonia or abrasives. The use of a lens cleaning disc at least once a month can also prolong unit life. Attachments Do not use attachments not recommended by your dealer as they may cause harm to the unit. Only use the specified attachments/accessories with this unit. Servicing Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. These units are not user serviceable, never attempt to repair, disassemble or reconstruct the unit if there seems to be a problem. A serious electric shock could result if this precautionary measure is ignored. Contact the service department should any of these conditions occur: - When the power-supply cord or plug is damaged. - If the unit does not operate normally after following the operation instructions, adjust only those controls that are covered by the operation instructions. - When the unit exhibits a distinct negative change in performance. iD10 Docking Station for Apple® iPodTM User's manual This Docking Station enables you to get the best sound quality from your iPod by both allowing you to charge the iPod battery and play music from your iPod on your home stereo system. Docking adaptor slot Dock connector Remote sensor Contents 1 2 3 1 2 1 x Docking station 1 x UK power supply 3 x Docking adaptors 3 x3 Dock adaptors The iD10 comes with 3 types of docking adaptors. Insert the dock adaptor that fits your iPod model, then plug in your iPod. iPod models supported iPod Nano (2GB/4GB and 8GB) iPod (20GB/40GB and U2 Special Edition ) iPod with colour display (40GB/60GB and 80GB) Note: The docking station does not support iPod Shuffle. Connecting your iD10 1 Audio In 2 12V DC IN 1 Audio output Connect your docking station to your amplifier/stereo system (3. 5mm to Dual Phono - not included). 2 3 12V DC input Connect your docking station to the supplied AC adapter. * AV Cable not included Docking adaptor Fit the correct docking adaptor for your type of iPod. Using your iD10 1. Press Play on iPod/remote control. Note: The iD10 is also compatible with Cambridge Audio Azur Navigator remote controls supplied with our products which support 'iPod Control' (currently this is almost any remote in our Azur range). iD10 Accessory Pack (Not included, sold separately) An iD10 Accessory Pack (C3037) is available for purchase from your Cambridge Audio dealer. The pack consists of: 1 2 Audio Cable (3. 5mm to Dual Phono/ RCA stereo mini-jack) Remote Control 1 2 Remote control Power Menu Press to switch the iPod on/off. Press to go back to the previous menu. Navigate Press to navigate up/down. [. . . ] Some countries and US states do not allow the exclusion or limitation of incidental or consequential damages or implied warranties so the above exclusions may not apply to you. This Warranty gives you specific legal rights, and you may have other statutory rights, which vary from state to state or country to country. Visit www. cambridge-audio. com and register to receive notification of future hardware and software releases. This guide is designed to make installing and using this product as easy as possible. Information in this document has been carefully checked for accuracy at the time of printing; however, Cambridge Audio's policy is one of continuous improvement, therefore design and specifications are subject to change without prior notice. [. . . ]