User manual CAMBRIDGE AUDIO AZUR 650BD

[. . . ] Blu-ray player User's manual 2 azur 650BD Your music + our passion ENGLISH Contents Make sure you register your purchase. Visit: www. cambridge-audio. com/care By registering, you'll be the first to know about: G Future product releases G Software upgrades G News, events and exclusive offers plus competitions! This guide is designed to make installing and using this product as easy as possible. Information in this document has been carefully checked for accuracy at the time of printing; however, Cambridge Audio's policy is one of continuous improvement, therefore design and specifications are subject to change without prior notice. This document contains proprietary information protected by copyright. No part of this manual may be reproduced by any mechanical, electronic or other means, in any form, without prior written permission of the manufacturer. [. . . ] You can also choose to restrict BD-Live access using the player's Setup Menu. TV system selection The 650BD can be set to output all video as PAL or NTSC or output the video in the same format it was recorded in (Multi). Some TVs only support PAL or NTSC and not both so forcing the output type to one or the other can be useful. Press and hold the Res/TV Type button on the remote control to cycle the video output to PAL, NTSC or "Multi" system. Some points to keep in mind: · When the video output is set to PAL or NTSC, the player will convert the disc content if different to the selected system. · When the video output is set to "Multi", the player will not perform system conversion and will output the video in its native format on the disc. The "Multi" mode should only be used if your TV supports both NTSC and PAL systems. In this case keep holding the Res/TV Type button until a supported system is selected. · The output system selected with the Res/TV Type button will be remembered when the player is turned off. The output system selection can also be done by setting the "TV System" item in the "Video Setup" section of the player's Setup Menu. Output resolution If you would like to change the output resolution, you may do so by pressing the Res/TV Type button on the remote control: 1. Although the output resolution can be changed "on the fly", it is recommended that you stop playback and take out the disc before changing the output resolution. In case the TV does not support the current resolution and you cannot see the "Resolution Setting" menu, the current resolution is also displayed on the front panel. Pressing the Res/TV Type button cycles through the available output resolutions. The new resolution is displayed on the front panel just in case you cannot see the "Resolution Setting" menu (if it is incompatible with your TV). Or, if you do not want to change the output resolution, press the button. The following output resolutions are available: PAL output via HDMI ­ Auto, 1080p, 1080i, 720p, 576p, 576i, Source Direct. NTSC output via HDMI ­ Auto, 1080p, 1080i, 720p, 480p, 480i, Source Direct. * When 1080p is selected with component output selected as the primary video output, HDMI output resolution will be 1080p and component output resolution will be 1080i. Note: · Some TV sets do not support one more output resolutions (particularly 1080p). If an incompatible output resolution is selected, you will get a blank screen or an error message. In this case please select an output resolution that is supported by the TV. · In case you are not able to get a picture using the HDMI or component output, please connect the player to the TV using the composite video output, then use the Setup menu to adjust the player settings. · Video up-conversion over the component output is only available for unencrypted discs such as home video and consumer-created contents. [. . . ] Televisions have brightness (black level)and contrast (white level) controls; however it may require a combination of tweaking both the player and your television to get the optimal result. First adjust the television's picture controls for the best possible picture. Once that is done, try changing the player's settings to further refine the picture to the optimal result. This control only applies to analogue video output (component and composite) Saturation ­To adjust the saturation (colour intensity level) of the video output. [. . . ]