User manual CAMBRIDGE AUDIO 89

[. . . ] Congratulations on purchasing this Cambridge Audio 80 Series DVD player. The DVD85, 86 and 89 models all support normal CD and DVD discs, while the DVD89 is also a `universal' player that supports DVD-Audio (DVD-A) and Super Audio CD (SACD). These new audiophile formats allow even greater sound quality than CD/DVD and also allow multichannel surround-sound audio. In addition, the DVD85, 86 and 89 all support DivX® playback for good quality highly compressed video and audio often downloaded from the internet. [. . . ] All of these menus are accessed from the blue Cambridge Logo screen that appears when the DVD player is on with no disc in the tray. SACD: Allows you to switch between 2 channel, multi channel and CD Mode output. PSCAN: Allows you to switch between interlace and progressive scan outputs via the component video connections. DVD89 Only When you press the setup button two options will be displayed, common and professional. Press the common setup, to setup basic functions, or the professional setup for more advanced settings. Front, Centre and Rear Speaker Settings: adjusts the DVD decoder to compensate between large and small speakers and the size of the signal it sends to the subwoofer. If it is present the low frequencies are split off and sent to the subwoofer, if not the complete audio spectrum will be heard through the front channel. Channel Delay: Allows the distance between the listening position and the centre, subwoofer, rear left and rear right speakers to be individually set (in cm). This is to enable the surround sound to be optimised for different listening room sizes and shapes. You will need a suitably equipped television to handle a component signal. Screensaver: If the DVD is left on and inactive, it will switch to a screensaver to minimise energy consumption and screen burn. Subtitle: Setting a particular language here means that the DVD will look for this particular language. Parental: Adjusting this blocks films above a set classification level (ie PG13) from playing on the player if children are using it, if you wish. The password default is 7890 and can be changed by correctly entering the default followed by your new password. Default: This can restore all of the original factory settings if required. When the disc tray has opened fully, place a disc carefully in the tray with the label side facing up. When the tray with a correctly loaded disc is fully closed, the disc will start turning automatically. The disc tray can be opened at any time by pressing the OPEN/CLOSE button. Note: Do not put anything except a DVD/CD sized disc into the tray, foreign objects may damage the mechanism. Do not force the tray by hand during the opening and closing operations. to avoid dirt and dust entering the mechanism , keep the disc tray closed. If the Disc is seriously scratched or too dirty the player may not be able to read it or play it. [. . . ] For stereo buffs, a DVD-Audio disc can alternatively hold two channels of 24-bit/192 kHz audio, exceeding the quality of any music audio format previously available. When you have unpacked your remote handset, insert the supplied AAA batteries to activate it. The remote can control all of the standard playback options but is also important in setting up your DVD player as many of the menus are most easily accessed from the remote. Keep in mind the following when using the remote control: · Make sure that there are no obstacles between the remote and the remote sensor on the unit. [. . . ]