User manual C-SCOPE CS4PI

[. . . ] 7) Rotate the Pulse Frequency control to the start of the green zone on the scale. With the searchhead off the ground and well away from any metal object listen for interference. If necessary switch to a different frequency within the green zone where the detector is silent and interference free. [. . . ] Adjust the position of the search-head so that it is parallel to the ground when the user is in a normal standing position. Friction of the head lugs against the neoprene washers keeps the search-head in position. (If some form of lubricant should ever find its way onto these washers it will be necessary to disassemble the parts, wash and dry them before careful reassembly). 4 belt mounting Squeeze the control box retaining clips together using your thumbs a shown in the photograph. The control box will now slide towards you free of the control box mounting clip. In belt mounted use be sure to wind the search-head cable up the stem at least to the length adjuster and secure it with tape or cable tie. This is because the search-head is sensitive to metal objects above to some extent and the lead will be detected if it is left free to move. CS4PI Above: Slide the belt mounting clip into the fixing slots on the underside of the control box and push all the way until the retaining lugs click into position 5 batteri Undo the 4 battery compartment retaining screws and take out the battery holder. Fit 8 good quality AA type batteries into the compartments of the battery holder. Observe polarity of the batteries (the spring contact goes against the flat, negative end of the battery). Roll the batteries in the holder to ensure good contact and replace into the battery compartment with the contacts on the holder lining up with the contacts in the compartment. Replace the battery compartment cover being very careful to avoid cross threading the screws. Battery condition can be checked by switching to the red battery symbol to the left of the Pulse Frequency scale. When the battery check switch position is selected, the detector will emit an audio tone proportional in length to the condition of the batteries. (After the battery check procedure the detector continues to `beep' about every 8 seconds if the switch is left in the battery check position. This is just a reminder to you to switch off). deing with the CS4PI Successful treasure hunting starts with a well researched site. Sweep the detector head from side to side with a steady relaxed motion. Keep the search-head parallel and as close as possible to the ground right across the arc of the sweep. [. . . ] Acquaint yourself with any laws relating to the use of metal detectors if you want to go detecting in countries other than the UK. CS4PI deor care The CS4PI is a robust design, however the control box should be treated with similar care as any electronic product. Stem and search-head parts should be cleaned and dried at the end of a day's detecting. If the detector has been used on a beach it will be necessary to wash sand and salt residue off the stem adjustment mechanism and the search-head retaining parts using tap water. [. . . ]