User manual C-SCOPE CS1MX

[. . . ] The CS1MX is extremely easy to use but you will be a better treasure hunter if you take the time to read this manual carefully and understand what the controls are doing. 4 CS1MX - Rapid get you going instructions Assemble and adjust for length. Insert battery so that the terminals line up easily with the contacts in the battery compartment. [. . . ] Turn the control to the recommended setting (marked green on the scale 2 - 5) and signals from small iron objects are ignored. Turn the control further (5 - 10) and more classes of metal target are ignored, such as larger iron pieces and some aluminium based alloys at the top of the scale. However, high levels of discrimination are not recommended for general detecting purposes, due to the reduced depth penetration and also because some valuable items (thin section hammered coins and some rings) may fall into the same category as rubbish and not be detected. Wind the search-head lead (9) around the stem as shown in the photograph. Adjust the stem for length according to your height (it's easier on your back if you can stand up straight while detecting) and tighten the twistlock stem adjuster (6). Check that the search-head (7) is parallel to the ground when being swept in an arc and tighten (be careful not to over-tighten) the search-head retaining screw (8). (Keep these parts clean - if they become covered in mud or sand wash and dry these parts at the end of a day's detecting. Don't allow any form of lubricant onto the rubber friction washers. ) Battery: Push back the retaining clip and remove the cover (13) of the battery compartment (12). There are guide strips to ensure the battery is fitted the right way round. It should slide in easily to connect with contact strips in the compartment. Remove the battery if the detector is to be stored for more than a few days. Searching Technique Sweep the detector head from side to side in a smooth arc. Keep the search-head as close to the ground as possible, even at the ends of the arc where there is a natural tendency for the search-head to lift. Maintain a strict search pattern so that the area being searched is completely covered. [. . . ] warranty & Service The CS1MX is guaranteed free of manufacturing defects as confirmed in our written warranty document. Contact us if you have any concerns about the operation of your detector. [. . . ]