User manual BUSHNELL TROPHY TRS -25

[. . . ] Failure to do so could result in water leakage into the battery compartment. D) Verify that red dot is present by turning the Rotary Switch clockwise. Installing the Sight on the Firearm The Micro Sight is designed for installation on most types of weapons, which have a MIL-Std 1913 Picatinny Rail or Weaver Rail. [. . . ] c) Remove the Adjustment Cap for windage and elevation adjustment , one at a time. The two knobs incorporated on top of the Adjustment Cap (1) shall be used for adjusting the Screw. Reverse the Adjustment Cap and the knobs will fit into the two recesses on the Adjustment Screw. nOTE: Each click of the Adjustment Screw corresponds to a 13 mm movement of the point of impact at 100 meters , (3 mm at 25 meters and 26 mm at 200 meters or 1/2" at 100 yds). D) Insert the two knobs on top of the Adjustment Cap in the two holes on the Adjustment Screw and turn as follows: - To move the point of impact to the right, turn windage adjustment screw counter clockwise - To move the point of impact to the left, turn windage adjustment screw clockwise - To move the point of impact up, turn elevation adjustment screw counter clockwise. - To move the point of impact down, turn elevation adjustment screw clockwise. e) Confirm zeroing by firing at least three shots at a zeroing target. Check points of impact on zeroing target to confirm accuracy and repeat above procedure if required. OPERATION UNDER EXTREME CONDITIONS a) Extreme heat (moist or dry): No special procedures required. It could also make the Rotary Switch a little harder to turn than at normal temperatures. OPERATION UNDER EXTREME CONDITIONS (continued) Adjustment Caps are tightened before exposing the Sight to sea spray, mud, snow or before immersing the sight in water. Clean lenses with lens paper/cloth and wipe the sight dry as soon as possible after exposure to water, sea spray, mud or snow. E) Dust storms and sand storms: Keep Lens Covers closed when sight is not being used. CAUTION: The lenses shall never be cleaned with fingers but with lens paper/ cloth. If no lens paper/cloth available : - To clear away debris (sand, grass etc): blow away the dirt. - To clean lenses: mist up the lenses and clean them with a soft piece of cloth. Battery is not making good contact: Clean contact surfaces and reinstall battery. â· Impact point is moving: Check mount and weapon rail (or carry handle) stability. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ]