User manual BUSHNELL NIGHT WATCH

[. . . ] Be sure to observe the correct battery polarity, as shown on the left. The "+" end of the top battery should be facing out (towards the battery door), and the "-" end of the lower battery should be facing out. When finished using the unit, replace the cover to protect the objective lens (1) and IR light (7). To extend battery life, the unit will normally turn off automatically after 2 minutes (if no buttons are pressed). [. . . ] This can be helpful in improving the LCD display viewing quality (by avoiding "wash out") in very low light conditions or complete darkness. While moving from viewing one object to another object, it might be necessary to rotate the objective lens focus wheel and adjust the IR illuminator brightness in order to achieve the best image quality. The Digital Night Vision includes a video output ("TV Out") jack (13). This port allows one to transmit images to an external video monitor or video recorder. Plug the output video cable into the video output jack ("TV Out"). When the Digital Color Night Vision is connected to compatible (NTSC) video equipment, the image produced by the unit can be monitored and/or recorded. The Digital Color Night Vision also includes a 6 volt auxiliary power input jack (12). To connect the Digital Night Vision to a household outlet, use the included 6 volt AC power adapter. Note that this feature is not intended to recharge batteries of any type, and should not be used for that purpose. notE: When the batteries are inserted and the external power source is turned on, the device operates on the external power source. If you unplug the external power source, and you want to use the battery source, you have to press the ON button (3) to make the device operate. notE: A standard tripod mounting socket is provided on the bottom of the unit. Remove the round rubber plug near the center of the bottom face of the unit and set it aside. 4 trouBlEsHootInG unit will not turn on 1. If the batteries are installed correctly and the batteries are good, then the green LED indicator light should be on steadily. The unit normally turns off automatically after 2 minutes to conserve battery power. carE anD maIntEnancE Your Bushnell Digital Night Vision device was designed to provide many years of reliable service. To ensure that you get the most enjoyment out of your Digital Night Vision device, always obey the following warnings and precautions. · Donotopenthebodyofthedeviceorotherwiseattempttoservicethisdevice. · Keepthedeviceawayfromanyheatingandairconditioningventsorotherheatingdevices, directsunlight, andmoisture. · Avoiddroppingorotherwiseshockingtheunit. Althoughdesignedforruggedoutdooruse, thisdeviceincorporatesasophisticated digital circuitry which could be damaged in extreme cases of misuse. [. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ]