User manual BUSHNELL IMAGEVIEW 11-0512

[. . . ] When the camera is connected to your PC via the USB cable provided, the camera will power on automatically. Power off: While the camera is on, press and hold the button until camera turns off. If camera has not been used or if a button has not been pressed for over 2 minutes, the camera will automatically power off to save battery life. If the camera is connected via the USB cable, it will not power off except when PC is turned off. [. . . ] Low Resolution mode, will cause your pictures to be of a lower resolution, but will allow you to store many more pictures in the camera's memory. To change the resolution, press the MODE button until you see the "mode" icon appears. Repeat the same steps to change the camera back to Hi resolution mode. 6. To change settings, toggle through the different modes by pressing the MODE button. By pressing the MODE button the camera will enter "Mode Change". To select "Self-Timer" mode, press MODE and the self -timer mark appears, then press SNAP and the camera will take a picture after a 10 second delay. The camera exits self-timer mode automatically after capture is done and the self-timer mark disappears on the LCD at the same time. Pixels (Resolution) 1280X1024(Hi) 1024X768(Lo) Image Quality High quality (HQ) Low quality (LQ) High quality (HQ) Low quality (LQ) Captured Picture Quantity Up to 40 pictures Up to 55 pictures Up to 55 pictures Up to 85 pictures 3 Press MODE-> press SNAP to capture. 11. When in "Normal" mode press the MODE button 3 times to enter the "AVI" mode. It depends on what objects you are capturing and the lighting conditions. 4 12. To delete all pictures in the camera's memory, select the "Delete All" mode. Once complete, the picture number will reset to possible captured numbers. If the "delete Last" icon appears, the display will show the following: Press SNAP to delete the last picture in the camera's memory. The picture number will be automatically increased after deletion is done. To change the setting of image quality (default setting is High), Storage/PC Cam (default setting is Storage), 50 Hz/60 Hz frequency (default setting is 60 Hz). Select the image quality at Hq (High quality) or Lq (Low quality) by pressing the SNAP button. Select 50 Hz or 60 Hz settings for the camera output by pressing the SNAP button. The camera's default mode is the "60" mode, which matches the power frequency for the United States. To change to the "50" mode, press the SNAP button until the "60" changes to "50". To avoid any flickering on the picture, the correct power frequency (either 50 or 60) for your country must be selected. d. [. . . ] In the event of a defect under this warranty, we will, at our option, repair or replace the product, provided that you return the product postage prepaid. This warranty does not cover damages caused by misuse, improper handling, installation, or maintenance provided by someone other than a Bushnell Authorized Service Department. Any return made under this warranty must be accompanied by the items listed below: 1) 2) 3) 4) 5) A check/money order in the amount of $10. 00 to cover the cost of postage and handling Name and address for product return An explanation of the defect Proof of Date Purchased Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit, with return postage prepaid to the address listed below: IN CANADA SEND TO: Bushnell Performance Optics Attn. : Repairs 25A East Pearce Street, Unit 1 Richmond Hill, Ontario L4B 2M9 NOTES IN U. S. A. SEND TO: Bushnell Performance Optics Attn. : Repairs 8500 Marshall Drive Lenexa, Kansas 66214 For products purchased outside the United States or Canada please contact your local dealer for applicable warranty information. [. . . ]