User manual BUSHNELL BACK TRACK 360053 QUICK START GUIDE

[. . . ] Change batteries when low power is shown by the battery indicator icon. Make sure the battery contacts are clean and replace both batteries at once. HOLD Take the BackTrack Outdoors HOLD Mode/Power Button "Satellite" Icon Not Flashing 2. HOLD (keep pressed for 2 seconds) the MODE/POwEr button to turn on the BackTrack. [. . . ] Distance & direction to it are now displayed. Home Icon 158 yds distance in direction of the arrow to your campsite 7. Simply turn the BackTrack's power back on (HOLD the MODE/POwEr buttons) and the BackTrack display will indicate the direction and distance back to the most recent location you marked. If you want to return to a previous location, just PUSH the MODE/POwEr button to select the icon you used when you marked it earlier. To find your way back to the selected location, simply move in the direction the arrow points and watch for the distance to decrease. When you reach your destination, a full circle of arrows will be seen at the outer edge of the display. 7 returning to Compass Mode Compass Icon PUSH MODE/POwEr to select the "Compass" icon and use the BackTrack's Compass Mode To use the BackTrack as a digital compass, simply PUSH the MODE/POwEr until you see the "Compass" (Arrow) icon, and the BackTrack will again display an arrow pointing North, and the compass degrees for the direction it's pointed (see red arrow above). To ensure directional accuracy, hold the BackTrack out horizontally in front of you (parallel to the ground) and move it in a "figure 8" pattern a few times to re-calibrate the compass. 8 8 Changing the Distance Units · To change the units from English to Metric, HOLD both the MArK and MODE/POwEr buttons when any of the three location icons is selected- the distance units display changes from "yd" to "m". The BackTrack will automatically switch from yards to miles (or meters to km) for longer distances. Turning on the Backlight · PUSH MARK to turn on the display backlight at anytime. Auto Power Off · Power automatically turns off after 10 minutes if no buttons have been pressed, or HOLD down MODE/POwEr to turn off manually. When the BackTrack is turned back on, it returns to the last mode you selected. Other Operations HOLD HOLD PUSH In a Location Mode HOLD both MODE/POwEr and MArK to select English or Metric units for displayed distance (yd & mi or m & km). PUSH MArK to activate backlight. 9 warnings and Notices GPS System & Location Accuracy Notice: The Global Positioning System (GPS) is operated by the government of the United States, which is solely responsible for its accuracy and maintenance. The system is subject to changes which could affect the accuracy and performance of all GPS equipment. The inherent nature of the GPS system itself limits the accuracy of the distance indicated on the BackTrack's display to within about ±3~5 meters (or yards) of the actual marked location. warning: This device is intended as a supplemental handheld navigation aide only. The user assumes all responsibility associated with the use of this product. It must not be used for any purpose requiring precise measurement of location, direction, distance, velocity or topography. This device should not be used for any aircraft navigation applications. Vehicular Use Notice: Bushnell is committed to the safe and responsible enjoyment of the outdoors. An accident can result in property damage, injury or death if the operator fails to practice prudent driving practices. It is the sole responsibility of the driver of any vehicle to operate the motor vehicle in a safe manner. Information from the GPS unit can distract the operator of a motor vehicle. It is unsafe to operate the controls of the GPS unit while operating a motor vehicle. If used in a motor vehicle, it must not be used by the operator of the motor vehicle. [. . . ] This warranty does not cover damages caused by misuse, improper handling, installation, or maintenance provided by someone other than a Bushnell Authorized Service Department. Any return made under this warranty must be accompanied by the items listed below: 1) A check/money order in the amount of $10. 00 to cover the cost of postage and handling 2) Name and address for product return 3) An explanation of the defect 4) Proof of Date Purchased 5) Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit, with return postage prepaid to the address listed below: IN U. S. A. Send To: Bushnell Outdoor Products Attn. : Repairs 8500 Marshall Drive Lenexa, Kansas 66214 IN CANADA Send To: Bushnell Outdoor Products Attn. : Repairs 25A East Pearce Street, Unit 1 Richmond Hill, Ontario L4B 2M9 For products purchased outside the United States or Canada please contact your local dealer for applicable warranty information. In Europe you may also contact Bushnell at: Bushnell Germany GmbH European Service Centre Mathias-Brüggen-Str. [. . . ]