User manual BUFFALO WLE-POE-R7 SETUP GUIDE

[. . . ] Power Over Ethernet Supply Connecting to your Power-Over-Ethernet Supply Adapter (WLE-POE-S) The WLE-POE-S Power Supply Adapter is an adapter for supplying power the AirStation. Using this product enables compatible AirStations or AirStations with a compatible POE Receiver Adapter to be used in locations that are not provided with a nearby power source. [. . . ] Connect the AC adapter to the AC outlet. AC outlet LAN cable AC adapter WLE-POE-S (power supply adapter) POE- compatible AirStation WAN port Use CAT 5 cable LAN port Hub, etc. Supplying Power to non-POE-compatible AirStations Connect the hub or PC to the LAN port of the WLE-POE-S Power Supply Adapter. Connect CAT5 cable between the POE ports of the WLE-POE-S Power Supply Adapter and the WLE-POE-R33/R7 Receiver Adapter. Adapter. Connect the AirStation to the LAN port of the WLE-POE-R33/R7 Receiver Connect the AC adapter of the WLE-POE-S Power Supply Adapter to the power outlet. LAN cable AC adapter DC cable AC outlet WLE-POE-S (power supply adapter) POE port LAN port Hub, etc. WLE-POE-R Adapter POE port LAN port DC Connector Use CAT 5 Cable AirStation 2 Connections NOTE: Using a cable other then CAT5 may prevent the supply of power to the AirStation. Thus, the total length of cable allowed between the Power Supply Adapter and the POE Receiver is 100 meters. Compatible AirStations POE-compatible AirStations * WLM-L11G Non-POE-compatible AirStations (These models require the WLE-POE-R33/R7 Receiver Adapters, sold separately. ) * WBR-G54 * WBR2-G54 * WHR3-G54 * WLA-G54 * WLA-G54C * WLA2-G54 * WLI-TX1-G54 * WLI2-TX1-G54 * WLA-L11G * WLA-AWCG * WLA-AWCG * WLAR-L11G-L * WLAR-L11-S * WLAR-L11-M Compatible POE Receiver Adapters * WLE-POE-R33 (For 3. 3v AirStation Products) * WLE-POE-R7 (For 7v AirStation Products) NOTE: The WLE-POE-S Power Supply Adapter uses the IEEE802. 3af standard and injects 48V over the CAT5 cable. The WLE-POE-S Power Supply Adapter can be used with IEEE802. 3af POE Receiver Adapters. However, it is recommended to always use the WLE-POE-R33 or WLE-POE-R7 POE Receiver Adapters in conjunction with Buffalo AirStation products. 3 Specifications Specifications 100 Mbps (100BASE-TX) 10 Mbps (10BASE-T) RJ-45 modular connector 100BASE-TX / 10BASE-T dual purpose port (for connecting the POE Receiver Adapter) 100BASE-TX / 10BASE-T dual purpose port (for connecting a hub or PC) 100 to 240 VAC, 50/60 HzV 48 VDC 0. 3A 250mW Temperature: 0 to 40 degrees C Humidity: 20 to 80% (non-condensing) 109 (W) x 23 (D) x 45 (H) 240g Transmission Rate Connector POE Port LAN Port Input Power Supply (AC) Output Power (POE) Maximum Output Current Maximum Current Consumption Operating Environment Dimensions (mm) Weight 4 FCC Statement FCC Statement This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case, the user will be required to correct the interference at his own expense. All rights for this setup guide are owned by Buffalo INC. No part of it may be transmitted, reproduced, or revised without expressed permission from BUFFALO INC. The names of other products used in this manual are trademarks or registered trademarks. Trademark symbols are not indicated in this setup guide. Specifications, designs and other descriptions in this manual are subject to change without notice. This setup guide has been carefully prepared, however, feel free to contact technical support if you have any questions or problems. [. . . ] * If using the product for applications with devices and computer systems requiring higher reliability than general-purpose OA devices, be sure to configure the system with an appropriate safety design and measures against failure. 5 6 Notes This page intentionally left blank. 7 4030 W. Suite 120 Austin, Texas 78759 Tel: 800-456-9799 Fax: 512-794-8606 Technical Support is available 24 hours a day, 7 days a week (USA / Canada) Toll-Free: 866-752-6210 email: info@buffalotech. com ©2004, Buffalo Technology (USA), Inc. [. . . ]