User manual BUFFALO HD-QLU3 DRIVESTATION QUAD USB 3.0

[. . . ] Power On: blue RAID Maintenance: purple These indicate the status for each internal hard drive of the DriveStation. Power On: green Accessing: blinking green Rebuilding: blinking red Error: red (see Troubleshooting) Connect to your computer with the included USB cable. Important: Please remove the cardboard shipping insert from behind the front panel of the DriveStation before use!Auto power mode will turn the DriveStation on and off automatically with your computer, or you may turn the DriveStation off manually. [. . . ] This divides the drive area into partitions not exceeding 2 TB for formatting. When formatting a capacity larger than 2 TB in Windows Vista, selecting "NTFS (GPT)(Recommended)" enables the creation of drive areas larger than 2 TB. When the message "If the disk configuration is changed, all data on the drive will be erased. When "Check again that there is no important data on the target drive. " is displayed, disconnect the DriveStation from the computer, then reconnect it. Notes: For users of Windows Server 2003 After building the RAID array, the DriveStation must be initialized using the NTFS format. format the DriveStation while referring to the on-screen manual "Formatting Guide". For Macintosh users After building the RAID array, the DriveStation must be initialized using the MacOS Extended format. initialize the DriveStation while referring to the on-screen manual "Formatting Guide". If the DriveStation is connected to a computer after building the RAID array, the access lamp may glow green and the DriveStation may not be recognized properly. In this case, turn off the power for the DriveStation, then turn it on again. Log" file is automatically created in the folder where the RAID Utility was installed (default installation directory is C:\Program Files\BUFFALO\HD-xLU3). System log records [2010/xx/xx xx:xx:xx][Information label][Log record content] Log recording date INFO=Information WARN=Warning ERR=Error Device log records [2010/xx/xx xx:xx:xx][Information label][P/N=xxxxxxxxxx][Log record content] Log recording date INFO=Information WARN=Warning ERR=Error In the RAID Utility, the RAID Maintenance function can be set for periodically checking for errors due to bad sectors and automatically rebuilding when an error is found. You may continue to use the DriveStation during RAID maintenance, but this increases the time required for RAID maintenance to complete. to see the time remaining , hover the mouse cursor over the RAID maintenance icon. However, if the time remaining is more than 24 hours, it will not be displayed. If a previous error occurred during RAID Maintenance During rebuilding If RAID Maintenance is already running RAID maintenance execution schedule The available settings for the execution schedule of the RAID Maintenance are shown below. Every week (The day of the week can be specified from Sunday, Monday, Tuesday, Wednesday, Thursday, Friday, and Saturday. ) Week (1, 2, 3, 4) (The day of the week can be specified from Sunday, Monday, Tuesday, Wednesday, Thursday, Friday, and Saturday. ) Weeks 1 and 3 (The day of the week can be specified from Sunday, Monday, Tuesday, Wednesday, Thursday, Friday, and Saturday. ) Weeks 2 and 4 (The day of the week can be specified from Sunday, Monday, Tuesday, Wednesday, Thursday, Friday, and Saturday. ) 1st of every month The execution time can be specified in one-hour intervals from 00:00 to 23:00. [. . . ] SecureLockMobile encrypts the data on your DriveStation, preventing it from unauthorised access. * For best results, this drive should be connected to a high-speed USB 3. Sobald "Check again that there is no important data on the target drive. Um POP before SMTP zu verwenden, wählen Sie "Use [POP before SMTP] ([POP before SMTP] verwenden)" und geben dann Adresse, Portnummer, Benutzerkonto und Passwort des POPServers ein. [. . . ]