User manual BRITAX STEELCRAFT AGILE

[. . . ] stroller frame opening. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . to fit and remove the wheel guards. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . rear wheel fitting and removal. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . front wheel fitting and removal - 4 wheel model. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 5. [. . . ] repeat steps a, b & c for the other side. D the armbar can be released on one side and rotated out of the way to assist with putting a child in the stroller. to do this, press in and hold the release button, then disconnect one side of the armbar. E rotate the armbar clear of the stroller seat. Lock the armbar back into position after fastening the child in the harness. 16 strOLLEr assEMbLY & OpEratiON 13. aDjUstiNg thE backrEst CAUTION:Ensurethatyourchild'slimbsareinsidetheseatingareabeforeadjustingthe backrest. Bepreparedtosupportyourchild'sweightwhenadjustingthebackrest a to adjust up or down , fully lift the adjusting lever all the way up. b continue to hold the lever up and adjust the seat to any one of three positions. c there are 3 indicated seat positions while the seat is facing forward or rearward. 1. strOLLEr sEat rEMOVaL warNiNg - always remove your child from the stroller seat before removing, installing or changing seat direction. a to remove the seat, firstly, place the seat in the most layback position #3, see section 13c. b hold the seat or armbar on both sides with your hands. then with your finger or thumbs, press down and hold the grey buttons. c while holding the grey buttons, lift the seat out of the frame. 17 strOLLEr assEMbLY & OpEratiON 15. tO facE thE sEat iN OppOsitE DirEctiON. warNiNg: always remove your child from the stroller seat before changing seat direction. a refer to section 14 for removing the seat from the frame. b refer to section 11 for fitting the seat to the frame. 16. tO aDjUst thE hEaD piLLOw & shOULDEr harNEss hEight NOtE: the head pillow has a small height adjusting range for additional comfort. a the head pillow height is adjustable. the harness shoulder strap height also moves with the head pillow. b Unzip the pocket located on the rear side of the stroller seat to reveal the head pillow slider. c hold the slider and squeeze the two buttons together. slide up or down to adjust the head pillow height as desired, then zip the pocket closed. 18 strOLLEr assEMbLY & OpEratiON 17. tO fit, UsE aND rEMOVE thE caNOpY a to attach the canopy, slide the canopy mouldings onto the frame mouldings until they connect together. b attach the canopy hook strips to the pile strips around the top of the frame for a secure fit. c to adjust the canopy, open by pulling forward, or close by pushing it backward. D for extra protection, pull visor out from under front of canopy. E to expose the mesh section of the canopy, unzip the center section. f the zip should be fully unzipped to expose the center mesh section. 19 strOLLEr assEMbLY & OpEratiON 17. remove the reversible seat pad & shoulder pads. c to fit the footmuff into the stroller, first unzip the top section from the padded bottom section and set the top section aside. place the padded bottom section into the stroller seat. D thread the harness through the slots in the footmuff. start by threading both lap strap buckle prongs through the pair of slots in the middle section of the footmuff. E the footmuff features 3 pairs of shoulder strap slots to cater for different shoulder strap height positions. thread the shoulder strap buckle rings through the appropriate shoulder strap slots in the footmuff. f thread the buckle housing & crotch pad through the crotch slot in the footmuff. fit the reversible shoulder pads if desired. 24 strOLLEr assEMbLY & OpEratiON 25. tO UsE thE fOOtMUff - cONtiNUED g the footmuff is now ready for use. Zip together the top & bottom sections of the footmuff. h Engage the other side of the armbar (see section 12). roll the top section of the footmuff over the armbar and secure with the elastic and toggle if required. 26. tO fit thE MEsh cOVEr a to fit the mesh cover over the stroller seat or infant carrier, place the elastic section of the mesh cover over the front section of the canopy. b wrap the elastic loops around the stroller handle tube and attach together using the clip. c when fitted to the stroller, the front section of the mesh cover will rest on the leg support. 25 strOLLEr assEMbLY & OpEratiON 26. tO fit thE MEsh cOVEr - cONtiNUED D Lift the fabric cover as required or lower for most protection. E to fit the mesh cover over the bassinet, place the elastic section of the mesh cover over the front section of the canopy. f wrap the elastic loops and clips around the hook and pile strips and attach together using the clip. g to fit the mesh cover over the second seat, place the elastic section of the mesh cover over the front section of the canopy. h wrap the elastic loops and clips around the bars at both sides of the second seat. i attach using the clip. 26 strOLLEr assEMbLY & OpEratiON 27. tO fit thE raiNcOVEr a1 to fit the raincover to the stroller - place over the stroller canopy as shown. [. . . ] to secure the child in the harness, push buckles (a) through the buckle rings (b) and into the buckle housing (c) until the buckle prongs snap into position. carefully adjust the harness by pulling the sliders (D) until the desired fit is achieved in the lap, shoulder and crotch straps. always adjust the harness when changing the seating position of the child. to release the buckle, squeeze the top and bottom buckle prongs (a). 41 sEcOND sEat assEMbLY & OpEratiON 31. [. . . ]