User manual BRITAX SERENITY

[. . . ] 4001100 Model 2406A CARE AND MAINTENANCE READ THESE INSTRUCTIONS CAREFULLY AND KEEP THEM FOR FUTURE REFERENCE. Regularly inspect and maintain your product to ensure the freedom of movements of the locking devices and security of components. To prolong the life of your nursery product keep it clean and do not leave it in the direct sunlight for extended periods of time. Removable fabric covers and trims may be cleaned using warm water with a household soap or a mild detergent. [. . . ] · When making adjustments to the rocker, always ensure that your child's body is clear of moving parts. · To prevent the risk of the rocker catching fire, do not place it near a radiator, an open fire or a barbecue. · This rocker is not intended for prolonged periods of sleeping. Should your child need to sleep, then it should be placed in a suitable cot or bed. · Do not allow children to use the rocker as a toy or interfere with the rocker when in use. THIS PRODUCT IS NOT INTENDED FOR COMMERCIAL USE. WARNINGS 02 www. britax. com. au www. britax. com. au 11 11. TO FOLD THE ROCKER NOTE: REMOVE THE CHILD FROM THE ROCKER BEFORE FOLDING THE ROCKER. A Before folding, remove the toy bar and rotate the rear static/rocking bar inside. To fold the rocker, holding the rocker at the front with your left hand, slide the button (1) across to the right and hold, then lift lever (2) up with your fingers and push the backrest forward until fully folded. PARTS LIST A B C D E F G - Metal frame - Fabric seat cover - Canopy - Toy bar with 3 toys - Head pillow - Shoulder harness pads - Vibration & Sound unit A A-1 A-2 B C D 12 12. REMOVE THE FABRIC SEAT COVER A The fabric seat cover is easily removable for washing. To remove, unfasten the two safety clips from the underside of the rocker. Remove the cover from the footrest first, then slide off the seat cover from the backrest. Place the cover back on by reversing the above process. E F G NOTE: THE STRAPS ON THE BACK OF THE ROCKER CAN BE ADJUSTED AS REQUIRED. 10 www. britax. com. au www. britax. com. au 03 1. ATTACHING & USING THE VIBRATION & SOUND UNIT NOTE: ATTACH THE VIBRATION & SOUND UNIT BEFORE UNFOLDING OR OPENING THE FRAME. A To insert the batteries, unscrew the battery lid from underside of the unit using appropriate screwdriver. Place batteries into the correct position observing the correct polarity and re-fit the battery lid. NOTE: GREY BUTTON 1 IS A SAFETY LOCK AND LEVER 2 IS THE BACKREST ADJUSTER. A TO ADJUST THE SEAT POSITION 1 2 WARNING: NON-RECHAGEABLE BATTERIES ARE NOT TO BE RECHARGED. SUPPLY TERMINALS FOR BATTERIES ARE NOT ARE NOT TO BE SHORT CIRCUITTED. B Attach and secure the Vibration & Sound unit into the front base of the frame. Stand the frame upright and slide the Vibration and Sound unit through the runners and clicking into position as shown. [. . . ] You should hear a "click" sound as frame locks into position. A TO FIT THE SHOULDER HARNESS PADS To fit the shoulder harness pads, push each shoulder harness through pads. WARNING: ENSURE THAT ALL THE LOCKING DEVICE ARE ENGAGED INTO POSITION BEFORE USE. A TO FIT & USE THE CANOPY To fit the canopy, put the canopy over the seat, make sure that the plastic lever at the back is not covered by the canopy and then simply slide the clip into both sides as shown. TO SECURE YOUR CHILD WARNING: Use this harness at all times. A A five point harness is provided to restrain your child. [. . . ]