User manual BRITAX SAFEFIX PLUS

[. . . ] No modifications may be made to the child safety seat other than by the manufacturer. Use the SAFEFIX plus exclusively for securing your child in your vehicle. The SAFEFIX plus is approved for two different methods of installation: with ISOFIX fastening and support leg (semi-universal) With the vehicle's 3-point seat belt and support leg (semi-universal) 1 with ISOFIX fastening and support leg (semi-universal) the ISOFIX fastening is based on semi-universal approval. The seat may be used only in those vehicles cited in the enclosed vehicle type list. [. . . ] Place the lap belt section 14 in the light red belt guides 15 on both sides of the seat base 12. The vehicle seat buckle 13 must not be positioned in the belt guide 15. Press down the clamping lever 17 of the dark red belt clamp 18 on the side of the vehicle seat buckle 13. Place the diagonal seat belt section 16 on the other side into the dark red belt guide 40. Pull firmly on the diagonal seat belt section 16, at the same time pulling up on the clamping lever 17 until it engages. The diagonal seat belt section 16 may only be clamped using the belt clamp 18 on the side of the vehicle seat buckle 13. Turn the turning handle 9 anticlockwise and pull out the support leg 6 until it rests firmly on the floor of the vehicle. The support leg 6 must never be suspended in mid-air or supported by other objects. Also ensure that the support leg 6 does not raise the child seat from the seat surface. Of course, you can also use the child seat in reclining position (see 5. Turn the turning handle 9 anti-clockwise and fold back the support leg 6. Pull up on the adjustment handle 10 and pull the seat shell 11 forward into the reclining position (see 5. Take the diagonal seat belt section 16 of the dark red belt guide 40 and give it a brief jerk. 6 To correctly install your child safety seat using the 3point belt For the safety of your child, please check that. The child safety seat is securely fastened in the vehicle, · The vehicle seat belt is tightened up and not twisted, The lap belt section 14 runs through both light red belt guides 15, · The diagonal belt section 16 is clamped with the dark red belt clamp 18 only, which is on the side of the vehicle seat buckle 13, The diagonal belt section 16 runs through the dark red belt guide 40 only, which is on the side opposite the vehicle seat buckle 13, Neither the buckle tongue nor the belt buckle 13 of the vehicle seat belt is positioned in the belt guides 15 of the child safety seat, The support leg 6 is firmly on the vehicle floor and the child seat does not move away from the seat surface, As a general rule: The more snugly the harness fits over your child's body, the safer your child will be. Please do not leave your child unattended in the child safety seat in the vehicle. Installation on the rear seat: Move the front seat forward far enough that you child's feet cannot hit the back rest of the front seat (to prevent risk of injury). Protect the child seat against intensive solar radiation when it is not actually in use. Allow your child to enter and exit the vehicle only on the side away from traffic. Make stops during longer journeys to give your child an opportunity to run about and play. A correctly adjusted headrest 20 ensures optimal protection for your child in the safety seat. The headrest 20 must be adjusted so that the shoulder straps 19 are at the same level as your child's shoulders or slightly above. [. . . ] Fabrics: All our materials meet very high requirements with regard to colour fastness when exposed to UV radiation. This is not a material defect, but rather a normal sign of wear which is not covered by the warranty. Buckle: Buckle malfunction is often due to accumulations of dirt and dust which may stop it from working properly. when processing claims , product-specific depreciation rates will be applied. [. . . ]