User manual BRITAX ROADSTER 2 IN 1 WALKER

[. . . ] TO DISASSEMBLE THE SEAT FRAME AND LEG SUPPORT TUBES NOTE: For safety, this product is not designed to be easily disassembled. To remove the leg support tubes, squeeze the tabs and pull the support legs up out of the base. C 8. TO REMOVE THE SOFT SEAT NOTE: For safety, the seat is designed to be secured to the frame. [. . . ] NOTE: All music buttons when pushed will stop other functions and return to music mode. Replace the lid, replace the screw, tighten screw to lock the battery lid. ASSEMBLY - WHEELS NOTE: For easier assembly, turn the lower base frame upside down. A B Insert the wheel posts fully into the holes located at each corner of the base using moderate force. Insert all 4 wheels. B C D NOTE: Clean grip pads regularly, using warm water with a household soap or mild detergent to maintain stopping performance. 5. WALKER FUNCTION WALKER MODE(FIXED SEAT POSITION): NOTE: To lock the support legs from Bounce into Walker mode, select one of the 3 height positions. A If in number 1 position Bounce mode, push in and turn the RED button towards the LOCK position. To lower the seat to number 2 or 3 position, push in and turn the RED button from Lock towards Jump mode. Now push down on the seat frame until you see the number 2 or 3 appear. NOTE: You might need to adjust the leg tube up or down a little to allow the LOCK pin to engage the support leg. D To release back to Bounce mode, push in and turn the RED button (on both sides) towards Jump indicator. INSTALLING THE ADJUSTING SUPPORT LEGS NOTE: There is a left and right support leg. A Identify the hole in the leg moulding and align this with the small post on the base. Push down with some force until the support leg locks into the base cavity. Install both support legs. B B C C D Pull up to make sure it is engaged. INSTALLING THE UPPER SEAT FRAME NOTE: At the top of each support leg, you will notice a spring loaded pin. [. . . ] D Pull up on each side to make sure the Seat frame is locked onto the support legs. BOUNCE FUNCTION NOTE: The Walker has one Bounce function & 3 height adjusting positions. BOUNCE MODE: A If the support legs are locked into a fixed height position, by pushing in the RED buttons and turning them towards the Jump indicator, this will put the support legs into Bounce mode. The Bounce mode will sit in the highest seat position, '1', when not locked. 07 [. . . ]