User manual BRITAX PREVIEW

[. . . ] · To avoid entrapment or pinching, do not fold or unfold stroller when child is in or around stroller. · Only use accessories and replacement parts approved by Britax Child Safety. · Read and understand these instructions before using this product. To ensure proper use, store this user guide in a convenient place so it can be consulted often. [. . . ] G). H To prevent front wheels from swiveling, turn wheels forward, then lift swivel lever up until engaged with notch (fig. H). 6 7 Operating Instructions Backrest Hood (cont. ) Operating Instructions A To lower backrest, press release button on each backrest recline adjuster, while lowering backrest to one of four available positions (fig. A). B To raise backrest, push backrest up until in one of four available positions (fig. F). Hood C To Attach Hood, press two attachment clips onto each side of stroller frame (fig. D). 8 D To Remove Hood, lift tab on each attachment clip (4x) to release from stroller frame. Release hook and loop fastener strips at rear of hood. G H To Collapse Hood, release each hood lock by pressing up at center (fig. H). 9 Operating Instructions Arm Bar Attachment Clip Operating Instructions Carrier Attachment (cont. ) A To Remove Arm Bar, release and remove each attachment clip, located under armrests (fig. IMPORTANT: If removing for use without arm bar, replace attachment clips. B To Install Arm Bar, release and remove each attachment clip, located under stroller armrests. Slide arm bar into slots on stroller armrest, then replace attachment clips (fig. B). E 4 Press carrier onto arm bar until clicks are heard, which confirms attachment (fig. E). F 5 Check installation by lifting carrier from rear to verify that both attachment hooks are engaged with the arm bar (fig F). Carrier Attachment Carrier Removal Arm Bar Attachment Hooks C 1 If arm bar is installed, remove zippered cover. If arm bar is not installed, Install arm bar with smooth side up (fig. 4 Place carrier rear facing in stroller, with attachment hooks aligned with arm bar (fig. To raise backrest, push backrest up until in one of four available positions (fig. 2 Squeeze release lever on restraint, while lifting restraint from stroller (fig. 3 If desired, reinstall zippered cover on arm bar. 11 10 Operating Instructions Harness Parking Brake Care and Maintenance · Periodically check that the parking brake works properly and locks both wheels securely. · Clean out any dirt or debris that may prevent the brake from working. Frame Fabric · Wipe the frame with a damp cloth and mild soap. Cleaning Plastic Parts: · Wipe with a damp cloth and mild soap. Use clean, dry cloth or towel to wipe away excess water and soap. Wheels A 1 Position harness around child. B 3 Loosen or tighten harness by sliding each (5x) adjuster to desired position (fig. B). · Periodically oil caster bolts and wheel axles with liquid silicone lubricant. If Stroller Gets Wet: · Dry stroller with a clean cloth or towel to prevent corrosion. [. . . ] Only use Britax approved child restraints or carriers with this stroller. It is not designed to be compatible with other child restraints or carriers. The use of unapproved accessories could cause this product to become damaged or dangerous. Limitations of Damages The warranty and remedies as set forth above are exclusive and in lieu of all others, oral or written, express or implied. [. . . ]