User manual BRITAX MULTI TECH II

[. . . ] 9 months – 6 years) Follow these operating instructions carefully and precisely. If this seat is not securely installed and your child is not strapped in correctly, your child and other passengers are exposed to the risk of serious injury in case of an accident. Please read through these operating instructions carefully, BEFORE installing your child seat. The Hampshire Trading Standards Authority and Britax recommend neither buying nor selling on used child seats. [. . . ] When the belt is tight, close the buckle on the side of the belt buckle and ensure that the lap belt and diagonal belt are secured (Insert in Fig. Close the belt buckle on the other side and ensure that only the lap belt is secured (Fig. As incorrect and If the belt buckle is no in the position that is market with a the seat cannot be correctly fastened (Fig. 9-25kg 2f 2g Place the harness around the car seat in front of the child seat, as illustrated (Fig. If your car has an eyelet in the glide rail of the set, this can alternatively be used (Insert in Fig. IMPORTANT – Do not install the fastening belts with luggage straps. 2h Loop the end of the loops of the fastening belts around the seat in front and back again, as illustrated 1 (Fig. Put the ends of the fastening belt toward the outside of the car seat and guide them through the loops 2 . When the support leg brackets are pointing to the front and the belts are not twisted, lock the buckle of the fastening belt into the tongues on the sides of the child seat 3 . Tighten the fastening belts by pulling the loose ends downwards evenly 4 . 1 3 2 4 2i Pull the support leg as far away from the back of the child seat as possible 1 (Fig. Lower the support leg as far as the floor, maintaining the correct angle 2 . 2 1 2j Finally, ensure that the fastening belts are fully tightened, by pulling down on the loose ends (Fig. The support leg must be resting on solid ground and not on the flaps of storage compartments or similar, at an angle of 100° to the horizontal (Fig. Use the angle measurer on the last page of these operating instructions, in order to check the angle of the support leg against the floor. Check whether the child seat is firmly installed by moving it back and forth, as well as sideways. If it is loose or if the support leg is not at an angle of 100° to the floor, you will need to reinstall it, so that it is secured at the correct angle. Installation of your child seat (positioned backward) in a rear middle seat 3a IMPORTANT – The child seat MUST always be used with a lap belt and diagonal belt (approved according to UN/ECE Directive No. IMPORTANT – Do not use any carrying points other than those described in these instructions and those labelled in the child restraint equipment. NEVER install a child seat backwards on a vehicle seat that is equipped with an airbag. 2 1 3j Finally, ensure that the fastening belts are fully tightened, by pulling down on the loose ends (Fig. The support leg must be resting on solid ground at an angle of 100° to the horizontal. [. . . ] 4 years – 6 years) 6a 6b Adjusting the child seat In order to remove the belt on the child seat, place the child seat on the floor. Press the adjustment button and simultaneously pull BOTH shoulder straps forward as far as possible (Fig. Lift the belt adjuster on the back of the seat and slide it up until the shoulder strap slots are on the top position in the headrest (Fig. 6c 6d Unhook both shoulder straps from the bracket on the back of the child seat (Fig. [. . . ]