User manual BRITAX KING PLUS

[. . . ] 3) If there is a front airbag: slide back all the way or nearly so, observe any instructions in vehicle owner's manual. 4) Cannot be used if the vehicle seat is equipped with only a 2-point belt. Yes no 1) no yes yes 3) yes yes 4) In the case of an emergency stop or an accident unsecured persons or objects may cause injury to other vehicle occupants. The child safety seat is always secured when it is in the vehicle, even if no child is being transported. [. . . ] Protect the child seat against intensive solar radiation when it is not actually in use. Allow your child to enter and exit the vehicle only on the side away from traffic. Make stops during longer journeys to give your child an opportunity to run about and play. A correctly adjusted headrest 20 ensures optimal protection for your child in the safety seat. The headrest 20 must be adjusted so that the shoulder straps 19 are at the same level as your child's shoulders or slightly above. Slide the headrest 20 until the shoulder straps are at the correct height. Fold the headrest 20 back onto the seat shell 11 to lock the headrest adjuster 21 again. Tighten the straps until they are in contact with your child's body. The hip belt 28 must lie as low as possible over your child's hips. Pull on the strap end 36 until you hear a clear click from the harness adjuster 35. The straps of the child safety seat are comfortable but FIRM fit around your child, · The shoulder pads 23 are in the right position on your child's body. Reclining position of the child safety seat To place the seat shell in the reclining position: Pull up on the adjustment handle 10 and pull the seat shell 11 forward. In an accident at a collision speed above 10 km/h the child safety seat could suffer damage which is not necessarily obvious. In such cases it is extremely important that you replace the child seat. To prevent damage or breakage, ensure that the child seat does not become jammed in the car door, seat runners, etc. Should the child seat be damaged (for example after dropping it) it must be inspected by the manufacturer. The function of the harness buckle is important for the safety of your child. The buckle tongues are ejected only slowly when the red release button is pressed. Remedy Wash out the harness buckle so that it functions properly once again: 1. Push the metal plate 30, with which the harness buckle 24 is fixed to the seat shell, on its side upwards through the belt slot 31. Cleaning the harness buckle Soak the buckle 24 in warm water with dishwashing liquid for at least an hour. Re-fitting the harness buckle Push the metal plate 30 on its side downwards through the belt slot 31 in the cover and through the seat shell. [. . . ] Push down the strap loops of the shoulder pads 23 onto the base 32 of the headrest adjuster 21. Disposal of packaging carton polystyrene (Styrofoam) cover plastic parts metal parts webbing buckle and tongue container for paperboard container for polystyrene garbage, thermal utilisation container corresponding to the label on the part container for metals container for Polyester garbage Next child safety seat Tested and certified according to ECE R 44/04 Group ll + lll ll + lll ll + lll Body weight 15 - 36 kg 15 - 36 kg 15 - 36 kg For this car/bicycle child seat / pushchair we provide a 2-year warranty against manufacturing or material defects. As proof we ask that you fill out the Warranty Card and retain it for the whole term of the warranty period, together with the Transfer Check signed by you and your sales receipt. In the case of a warranty claim, the Warranty Card must be returned together with the product. [. . . ]