User manual BRITAX KID PLUS SICT

[. . . ] Should your child be secured in the vehicle seat with only a 2-point belt, he or she could sustain serious injuries possibly resulting in death. In a van or minibus) only if the vehicle seat is also approved for use by adults. 3) If there is a front airbag: slide back all the way or nearly so, observe any instructions in vehicle owner's manual. 4) Cannot be used if the vehicle seat is equipped with only a 2-point belt. [. . . ] You can adjust the side parts 15 of the seat cushion 1 to three widths. € The seat cushion 1 must be adjusted in such a way that the adjustable side parts 15 are as close as possible to your child's lap without constricting him or her. Here is how you can adjust the seat cushion 1 to your child: Grasp the light grey adjustment buttons 16 on the exterior of the side parts 15 by both sides. Press both adjustment buttons 16 upwards and pull the side parts 15 into the widest position. Now press both adjustment buttons 16 again and adjust the side parts 15 to the desired width. 3 Adjusting the height of the headrest A properly adjusted headrest 3 ensures the optimum distribution of the diagonal belt section 6 and provides your child with the desired protection and comfort. € The headrest 3 must be adjusted in such a way that you can still pass two fingers between the your child's shoulders and the headrest 3. To adjust the height of the headrest 3 to fit your child: Grasp the adjustment handle 8 by the back of the headrest 3 and pull it upwards slightly. As soon as you have let go of the adjustment handle 8, the headrest will engage. 4 Reclining position of the backrest The backrest 2 of the child seat adapts smoothly to the slant of the vehicle seat. Please observe: The best possible protection can only be ensured if the vehicle seat is in its upright position. The backrest 2 of the child seat can be inclined backwards into a reclining position independent of the the vehicle seat. To do so, fold out the displacement angle 9 on the back of the backrest 2. Now incline the backrest 2 backwards until the displacement angle 9 lies flat along the back of the vehicle seat. Do not incline the backrest 2 farther than specified by the displacement angle 9. 5 Securing your child The KID plus SICT does not require installation in the vehicle. Fastening the vehicle seat belt Place the child seat on the vehicle seat. Please be sure that the backrest 2 lies flat along the back of the vehicle seat (see 3. If the headrest of the vehicle seat is bothersome, simply turn it around. Pull out the vehicle seat belt and guide it in front of your child to the vehicle seat buckle 10. The lap belt section 11 must lie as low as possible over your child's hips. If the backrest 2 conceals the belt holder 7, you can adjust the headrest 3 upwards. [. . . ] This is not a material defect, but rather a normal sign of wear which is not covered by the warranty. Buckle: Buckle malfunction is often due to accumulations of dirt and dust which may stop it from working properly. Please contact your retailer directly in the event of a warranty claim. when processing claims , product-specific depreciation rates will be applied. [. . . ]