User manual BRITAX HI-LINER SG

[. . . ] It has not been designed for home use and should only be used in your car. DO NOT attempt to dismantle, modify or add to any part of the child seat or change the way its harness or your car seat belts are made or used. NO modifications may be made to the child seat other than by the manufacturer. DO NOT leave loose objects, such as luggage or books, in the back of your car. [. . . ] Once you reach the top slots your child may continue to use the seat until their eye line is above the top of the seat shell. Changing the height of the shoulder straps To loosen the harness, press in and hold the harness release button and with your hand below the chest pads (dia 1a) pull BOTH shoulder straps forwards as far as they will go. Pull the yoke out from behind the seat and unhook one shoulder strap (dia 1c). Pull the cover from the top of the seat so that you can see the slots in the seat shell. Pass the shoulder strap though the chosen slot and hook the shoulder strap back onto the yoke (dia 1d). Rotate the exposed metal strap adjuster (dia 1e) and push it through the slot in the cover and through to the underside of the seat shell. Ensure that it rests horizontally so that it cannot be pulled back through the shell. Pull on the buckle to make sure that it is secure and that the strap adjuster does not come back through. Adjusting the crotch strap IMPORTANT - The buckle should always be positioned low down on your child's body. You must adjust the crotch strap to the correct length for your child BEFORE installing the child seat as it cannot be adjusted in the car. The crotch strap should only be extended when normal harness adjustment is not enough, i. Finally tighten the tether straps by pulling the loose ends downwards (dia 2k) until the footprop touches the floor. The footprop must rest on a solid floor - not on lids of storage boxes or similar. Once firmly strapped in, test the child seat by trying to move it back and forth and side to side. DO NOT rest the back of the child seat against the driver or front passenger seats. Installing your child seat (rearward facing) in rear middle seat IMPORTANT - This child seat has been designed to perform safely and independently of further external restraint. IMPORTANT - The child seat can be used with either a lap or a lap and diagonal seat belt. To change the position (if required) pull the support leg clips off of either side and slide the telescopic leg in or out (dia 3a). Once satisfied with the position of the support leg, refit the clips in the holes (inset). Place the child seat rearward facing with the back of the child seat positioned centrally between the driver and passenger seat. Extend the footprop fully and make sure that the footprop tether brackets are facing forwards and that the straps are not twisted. Lower the footprop and adjust the height so that it is within approximately 30mm of the floor (dia 3b). [. . . ] IMPORTANT - The child seat MUST only be used with a lap and diagonal seat belt. To change the position (if required) pull the support leg clips off of either side and slide the telescopic leg in or out (dia 4b). Once satisfied with the position of the support leg, refit the clips in the holes (inset). Push the vehicle front seat back to accommodate the child seat ensuring that any passenger directly behind will still be able to sit in a comfortable position. [. . . ]