User manual BRITAX BEEPA 4 IN 1 SERIES WA2819A3

[. . . ] This warranty does not apply to failure due to improper care, or normal wear and tear caused by product use. You may be charged for repairs if the product has been damaged accidentally. CUSTOMER SERVICE 4 in 1 Walker Distributed by: AUSTRALIA BRITAX CHILDCARE PTY. LTD. 55 006 773 600 99 Derby Road, Sunshine, Victoria 3020, Australia Phone: (03) 9288 7288 Fax: (03) 9311 5798 NEW ZEALAND BRITAX CHILDCARE NZ. Phone: (09) 443 0102 Fax: (09) 443 0120 Due to our continuing program of development, Britax reserves the right to alter the specifications, colour or design without any further notice. The Steelcraft trademark is the property of Britax Childcare Pty. [. . . ] Always store the product in a well ventilated area. DO NOT LEAVE YOUR CHILD EXPOSED TO THE SUN. · Never leave your child unattended, always keep child in view whilst in the walker. · Ensure the child can touch the floor or foot pedal with both feet, after adjusting the height of the walker. · Do not use accessories other than those supplied and approved by Britax. · Discontinue using the baby walker should any part become damaged or broken. · Double check assembly before child is allowed to use the baby walker. · To asvoid burns or injuries ensure, electrical cords, heaters, barbecues, fireplaces and other hot objects are guarded or out of reach. · To prevent injuries, always ensure the child is well clear of any moving parts when adjusting the baby walker. · The baby walker seat should not be used by children who can walk unaided. · To avoid serious injury or death, block stairs and steps securely before using the walker. · Use only on flat surfaces free of objects that could cause the walker to tip over. · Maximum weight or height for child using walker seat is 13kg or 81cm tall. · If used on carpets, the safety grip pads may reduce the walker speed. · Clean safety grip pads regularly to maintain stopping performance (see Care & Maintenance). SAFETY WARNINGS 02 www. britax. com. au www. britax. com. au 07 5. TO ADJUST HEIGHT AND USE BOUNCE FUNCTION PARTS LIST A 1 x Upper plate includes seat B 1 x Walker Car Bonnet C 2 x Support Legs D 1 x Lower base includes foot pedal E 1 x Car windscreen F 4 x Swivel Wheels G&H 2 x Handrails I 1 x Toy Fan J 1 x Toy Horn D NOTE: The support legs can be adjusted to three heights to allow for child's growth. A To adjust seat height turn support leg knobs to `Lock' position. Find the desired height indicated by the numbers 1 to 3 and release the buttons to lock into position. TO ADJUST FOOT PEDAL A A B C B 6. B E F G NOTE: There are 3 foot pedal positions. A B C Push button on foot pedal and slide to adjust to desired position. TO INSTALL AND REMOVE SEAT FABRIC Raise the seat back rest and cover with rear flap of seat cloth. Turn upper plate upside down, pull plastic seat slots over plastic molding to hold seat in place. [. . . ] Place car bonnet over front end of upper plate, push down to lock into place. To remove car bonnet gently pull front wheels away from either side of upper plate molding. Insert the handrails into corresponding holes found on left and right sides of upper plate. (Batteries not included) C FOOT PEDAL BATTERIES A Turn over lower base to locate battery housing in foot pedal. [. . . ]