User manual BRITAX BASIC BABY MONITOR

[. . . ] The baby seat can be used as a Travel System on all pushchair frames which are equipped with the "type A" adapter and which have been approved for use with RÖMER/Britax baby seats. Please observe the instructions on the use of child restraint systems described in your vehicle owner's manual. Never try to secure a child on your lap with the vehicle seat belt or by holding onto them. Always secure the baby seat onto the vehicle seat in a rearward-facing position. [. . . ] You can use your child safety seat as follows: Against the direction of travel On front passenger seat without front airbag on outer rear seat on centre rear seat with 3-point belt on a rearward-facing seat Yes yes yes no Always secure your baby in the baby seat using the seat belt. As a general rule: The more snugly the belt fits over your child's body, the safer your child will be. Never leave your baby unattended in the baby seat when placing it on elevated surfaces. The metal and plastic parts of the complete child safety seat system can heat up in the sun. Protect your child and the child safety seat against intense sunlight (e. This advantage means, however, that your baby must be in a semi-reclined position. Take your baby out of the baby seat as often as possible to relieve its spine. Even outside of the car, please avoid leaving your baby in the baby seat for too long. Push the light grey release button 4 on the With the release button pressed, now swivel 5 Let go of the release button 4 and swivel the This position prevents the handle 5 from being unintentionally swivelled backwards. C : For putting your baby in and when using as a Travel System D: For setting the baby seat down safely outside the car When the headrest is adjusted 16, the inclination of the backrest adapts to the age of the baby. The headrest 16 must be adjusted so that the shoulder straps 3 are at the same level as your baby's shoulders or slightly below. The baby seat can be used as a Travel System on all pushchair frames which are equipped with the "type A" adapter and which have been approved for use with RÖMER/Britax baby seats. Carrycots, pushchairs and buggies must be only used to transport babies or children. Always apply the brake before fitting the infant carrier onto the pushchair or removing it. Push up the light grey release button 29 on the Travel System Adapters on both sides of the baby seat. Push the light greyreleasebutton 34 on the Lift the baby seat until the fixation prongs 30 are Keep a firm grip on the infant carrier while doing this. You can now remove the baby seat from the The following additional items are available for the baby seat: a rain cover, a cosytoes, a Keep Cool cover and a summer cover. for the protection of your baby · Never use the rain cover in your vehicle, indoors, in warm weather or near sources of heat otherwise your child could be exposed to the risk of a heat eshock. When using the foot muff, also ensure that the harness fits close around your baby's shoulder and hips and is tight. Always make sure that plenty of fresh air can get in under the rain cover 35. Pull the elastic seamofthe rain cover 35 over the Make sure that the vent holes 36 are above the Close the flap 37 over the handle 5 using the To carry the baby seat, simply open the flap 37 and take hold of the handle 5. Layyour baby in the foot muffand make sure that The vehicle seat buckle tunnel 39 is between the legs. [. . . ] Should the child seat be damaged (for example after dropping it) it must be inspected by the manufacturer. Never use other spare parts or accessories than those supplied or approved by the manufacturer. The function of the harness buckle is important for the safety of your child. The buckle tongues are ejected only slowly when the red release button is pressed. [. . . ]