User manual BRITAX B-LITE

[. . . ] Make sure that no locks disengage accidentally while the pushchair is carried. When folding the pushchair frame make sure that you do not trap any part of yourself or others. How to unfold the pushchair: Hold the pushchair by both handles 2 and release the black hinged latch 1 on the right-hand side. Make sure that the rear cross brace is engaged completely at the top and bottom. [. . . ] How to secure your child using the harness: Push the buckle prongs16 on either side through the slots in the shoulder straps 17. Engage both buckle prongs 16 in the buckle housing 18 with an audible "CLICK. Always re-adjust the harness when changing the seating position of your child. How to undo the harness: Squeeze the top and bottom prongs 16 on the buckle housing 18. To undo the harness completely you will have to unhook the buckle prongs 16 from the shoulder straps 17. Use the pushchair for children under 6 months only with the backrest 20 reclined all the way back. With your other hand, grasp the adjuster 21 and push the small button 25 down. Pull the adjuster 21 on the adjusting strap 27 downwards until the backrest 20 has reached the desired inclination. How to raise the backrest 20: Hold the end of the adjusting straps 27 with one hand. With your other hand, push the adjuster 21 upwards until the backrest 20 has reached the desired inclination. How to put the leg support 23 up: Pivot the leg support 23 upwards until it engages. How to put the leg support 23 down: Pivot the leg support 23 up slightly. The B-LITE can be supplemented with a suitable raincover 40 and a cosytoes 41. Never use the raincover indoors, in warm weather or near sources of heat ­ otherwise your child could be exposed to the risk of heat shock. Always make sure that plenty of fresh air can get in under the raincover 40. Place the raincover 40 over the front hood edge and the seat area of the pushchair. Fasten the snaps 42 to the left and right on the inside of the frame tube. Thread the straps through the slots in the back part of the cosytoes 41. Thread the buckle housing 18 through the slot in the lower part of the cosytoes 41. You can remove the upper part completely and use the cosytoes as a seat insert. Regularly check that any screws, nuts, bolts and other fastenings are fully tightened. Regulary clean and lubricate the front swivel wheel units as dirty or dry units can have an adverse effect on manoeuvrability and steering. [. . . ] This is not a material defect, but rather a normal sign of wear which is not covered by the Warranty. Buckle: Buckle malfunction is often due to accumulations of dirt and dust which may stop it from working properly. please contact your retailer directly in the event of a warranty claim. when processing claims , productspecific depreciation rates will be applied. [. . . ]