User manual BRITAX ADVENTURE

[. . . ] In a van or minibus) only if the vehicle seat is also approved for use by adults. 2) The safety belt must be approved to ECE R 16 or a comparable standard (see test label on belt with an "E" or "e" in a circle). 3) If there is a front airbag: slide back all the way or nearly so, observe any instructions in vehicle owner's manual. 4) Cannot be used if the vehicle seat is equipped with only a 2-point belt. [. . . ] Fastening the vehicle seat belt Place the child seat on the vehicle seat. Please be sure that the backrest 2 lies flat along the back of the vehicle seat. If the headrest of the vehicle seat is bothersome, simply turn it around. Optimal protection is guaranteed only if the vehicle seat is in an upright position. Pull out the vehicle seat belt and guide it in front of your child to the vehicle seat buckle 10. Inserting the vehicle seat belt into the red belt guides of the child seat. Place the diagonal belt 6 and lap belt 11 on the side of the vehicle seat belt buckle 10 into the red belt guide 12 in the seat cushion 1. The seat belt buckle 10 must not be positioned in the red belt guide 12. Insert the lap belt section 11 on the other side of the seat cushion 1 into the light red belt guide 12 as well. The lap belt section 11 must lie as low as possible over your child's hips. Guide the diagonal belt section 6 into the dark red belt holder 7 of the headrest 3 until it slides behind the safety hook. Please also make sure that the diagonal belt section 6 runs above your child's collarbone and does not rest at his or her throat. You can also adjust the height of the headrest 3 when you are in the vehicle. You can regulate the distribution of the belt using the adjustable seat belt tightener of your vehicle. The diagonal belt section 6 may not guide forwards to the seat belt tightener. The belt lap section 11 runs through both sides of the light red belt guides 12 of the seat cushion, · The diagonal belt section 6 also runs through the light red belt guide 12 of the seat cushion on the side of the vehicle seat buckle 10, · The diagonal belt section 6 runs through the dark red belt holder 7 of the headrest, · The diagonal belt section 6 runs slanted towards the back. The straps are tightened and not twisted, · The seat belt buckle 10 must not be positioned in the red belt guide 12 in the seat cushion. The seat cushion 1 is fitted with a foldout cup holder 4 and a small tray 5. Reach into the finger plate 9 and fold out the cup holder 4 (or the tray 5) out until it locks into place. In an accident at a collision speed above 10 km/h the child seat could suffer damage which is not necessarily obvious. [. . . ] Fabrics: All our materials meet very high requirements with regard to colour fastness when exposed to UV radiation. This is not a material defect, but rather a normal sign of wear which is not covered by the warranty. Buckle: Buckle malfunction is often due to accumulations of dirt and dust which may stop it from working properly. when processing claims , product-specific depreciation rates will be applied. [. . . ]