User manual BRITAX 3 IN 1 PORTABLE COT

[. . . ] Do not place the cot where your child could reach medication, money, string, elastic, small toys or other small objects. Do not place the cot near trailing cords, leads or flexes such as cords or electrical leads, etc. Do not place toys or other objects in the cot which could provide a step or foothold to help the child climb out. Cots with padded rails should not be used if the covered fabric is torn or bitten through. [. . . ] Non removable fabric covers and trims may be cleaned using a damp sponge with soap or mild detergent. B C In some climates the covers and trims may be affected by mould and mildew. To help prevent this occurring, do not fold or store the product if it is damp or wet. To maintain the safety of your nursery product, seek prompt repairs for bent, torn, worn or broken parts. D WARNING: IF THE SIDES DO NOT LATCH FIRMLY OR THERE ARE HOLES IN THE MESH SIDES, DISCONTINUE USE IMMEDIATELY AND SEEK REPAIR. TESTED AND APPROVED ACCESSORIES Mattress by Steelcraft Bassinet by Steelcraft E/F Change Table by Steelcraft - series S600 - series S600 - series S600 THESE STEPS WILL ENSURE THAT THE COT IS CORRECTLY OPENED AND READY FOR USE. Stand the cot on its feet and undo the hook & loop straps that hold the mattress around the frame. C Remove the mattress and set it aside. E Starting with the short rails pull the centre up with both hands quickly until they are locked in place. (CAUTION: TAKE CARE, AS FINGER PINCHING CAN OCCUR IN THE CORNERS WHEN LOCKING THE RAILS IN PLACE. ) F Now do the same with the longer rails. NOTE: ALL THE TOP RAILS SHOULD BE LOCKED IN PLACE. THE CENTRE OF THE COT BASE MUST BE IN A RAISED POSITION TO ALLOW THE RAILS TO LOCK EASILY. G Holding one end of the cot clear of the ground, gently press down on the handle in the middle of the base until the base lays down flat. Then turn the handle clockwise to lock the base in position and fold the handle down so it lies flat in the cot base. G 04 www. britax. com. au www. britax. com. au 09 5. Connect the straight rod (tube with 2 holes at each end) to one of the corner rods. With the corner rod curved upwards, push the straight rod into the sleeve to one side of the change table by gathering the fabric until it protrudes out the opposite end. Connect the remaining corner rod to the protruding end of the straight rod by engaging the locking pins. Insert the keys into the corner mouldings of the cot and turn the keys back towards you in the direction shown to attach the change table to the cot. H TO OPEN THE COT (con't) Place the mattress into the cot with its padded side facing up. Secure the mattress to the cot by passing the loop straps through the slot in the cot base and pressing it into the hook attachment strips, sewn to the underside of the cot base. I A H B NOTE: ALWAYS SECURE THE MATTRESS BEFORE USING THE COT I 2. TO USE THE WHEELS A Push the brake lever down to lock, or lift the brake lever up to unlock. C D E NOTE: ALWAYS APPLY THE BRAKES WHEREVER AND WHENEVER YOU ARE USING THE COT. [. . . ] C C B D DISASSEMBLE AND STORE THE BASSINET AND CHANGE TABLE IN THE CARRY BAG. E Take the mattress and wrap it around the folded cot with the padded side facing inwards. D/E/F F Thread the straps through the plastic loops, pull them tight and secure using the hook and loop attachments. Finish covering the cot and close the zipper. NOTE: ALWAYS SECURE THE MATTRESS BEFORE USING THE BASSINET. [. . . ]