User manual BRITAX ROEMER VISIO

[. . . ] DO read the labels on the covers for washing instructions and do not tumble dry ­ drip dry only. DO regularly inspect the pushchair to ensure all parts are in full working order. DO ensure children are clear of moving parts and locking devices while making adjustments. DO periodically check that any screws, nuts, bolts and other fastenings are fully tightened. [. . . ] Folding Handle 1407. 001 - VISIO AX118 User Guide. indd 4-5 22/6/07 15:22:49 1. 4 years) 1a 1b Fitting and removal of the front swivel wheels Take each of the front swivel wheel assemblies and press them down onto each of the front legs. You will hear a "click" when they are locked into place (dia 1a). If you need to remove a front swivel wheel, press the wheel release lever (dia 1b) located on the underside of the wheel and lift the wheel assembly from the front leg. 5a 5b Extending and retracting the handles To extend each of the pushchair handles, press the button located at the top of each handle inwards (dia 5a), pull the handles towards you to extend (dia 5b). 2a 2b Unfolding the pushchair Holding the pushchair in a vertical position, lift up on the lock release latches (dia 2a). Push down on the foot lock with your foot whilst pulling both handles up firmly, opening the pushchair until the chassis locks into the open position (dia 2b). Ensure the frame locking latch has locked on both sides. 6a 6b Threading the underside chassis cover straps Place the pushchair on it's side to gain better access to the underside cover straps. Thread the strap back over the last D-ring and back through the first D-ring (dia 6b). Pull the strap tight. 3a 3b Fitting the bumper bar Whilst pressing the button on the bottom of the bumper bar, slide one side of the bar into the armrest socket in the position shown (dia 3a), release the button to engage the lock (dia 3b). Repeat this sequence for the other side. 7a 7b Adjusting the backrest Squeeze clips towards each other to release the backrest lock (dia 7a). Move the backrest into the desired position (dia 7b). 4a 4b Attaching the shopping basket Ensure the basket is fitted with the zips at the sides. Thread the front press stud straps through the metal loops attached to the front of the frame, press studs together (dia 4a). Thread the rear press stud straps around the rear legs and above the frame, press studs together (dia 4b). 8a 8b To adjust the calf support Lower the calf support by lifting up the release latches located underneath both sides of the calf support (dia 8a) and push the calf support down. Raise the calf support by lifting it until the release latches lock into place (dia 8b). 1407. 001 - VISIO AX118 User Guide. indd 6-7 22/6/07 15:22:53 2. Using the functions of your pushchair, continued Children up to 15kg (approx. Using your pushchair as an infant pram Children up to 9kg (or until your child can sit unaided) 9a 9b Using the front swivel wheel locks To lock the front swivel wheels into the locked position, align front wheels into a straight forward position and slide the wheel lock guide up (dia 9a). To unlock the front wheels, slide front wheel lock guide down (dia 9b). 12a 12b Open the bumper bar (see dia 3a and 3b). Close the bumper bar on the outside with the calf support on the inside. 10a 10b To use the pushchair brake IMPORTANT - Parking brake is to be used only when pushchair is stopped. IMPORTANT - To prevent the pushchair from moving, always use the parking brake when loading/unloading pushchair or making any adjustments. To lock rear wheels for parking or loading pushchair, depress foot brake (dia 10a). To release brake, simply lift up the foot brake to disengage brake from rear wheel hubs (dia 10b). IMPORTANT - Always use the brake pedal, as using the connecting bar will cause it to bend. 11c 12c 12d Lower the backrest into the infant carrier position (lowest position) (dia 12c) by squeezing and pulling the adjustment handle upwards. (dia 12d). 12e 12f For your childs comfort, unfasten the harness and move them away to the side of the pushchair (dia 12e). [. . . ] "D" rings are provided at each side of the seat for attachment of an alternative harness. 1407. 001 - VISIO AX118 User Guide. indd 12-13 22/6/07 15:22:59 6. Removing and refitting the covers and harness Children up to 15kg (approx. Removing and refitting the covers and harness, continued Children up to 15kg (approx. 4 years) 15a Unfolding the armrest pads To unfold the armrest pads, pull down on the fabric on the outer side and fold into the centre of the pushchair (dia 15a). 15f To remove the infant pad Unthread the harness (if it's in the toddler carrying position) (dia 15f). [. . . ]