User manual BRIGGS & STRATTON 9B900

[. . . ] For replacement parts or technical assistance, record below the engine model, type, and code numbers along with the date of purchase. These numbers are located on your engine (see the Features and Controls page). The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. MM/DD/YYYY Type: Code: Briggs & Stratton does not approve or authorize the use of these engines on 3-wheel All Terrain Vehicles (ATVs), motor bikes, fun/recreational go-karts, aircraft products, or vehicles intended for use in competitive events. [. . . ] Used oil is a hazardous waste product and must be disposed of properly. Check with your local authorities, service center, or dealer for safe disposal/recycling facilities. Remove Oil You can drain the oil from the bottom drain hole, side drain hole, or from the top oil fill tube. To prevent debris from falling into the carburetor, carefully remove the air filter assembly. To remove the excess engine oil, squeeze the foam element in a clean cloth. Install the air filter assembly onto the carburetor and secure with screw. 5% for each 1, 000 feet (300 meters) above sea level and 1% for each 10° F (5. Dirt or debris can restrict air flow and cause the engine to overheat, resulting in poor performance and reduced engine life. Keep the area around and behind the muffler (C) free of any combustible debris (Figure 13). N We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance and service of the engine and engine parts. WARNING: If you drain the oil from the top oil fill tube, the fuel tank must be empty or fuel can leak out and result in a fire or explosion. To empty the fuel tank, run the engine until it stops from lack of fuel. Briggs & Stratton Corporation will repair or replace, free of charge, any part(s) of the engine that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. This warranty is effective for and is subject to the time periods and conditions stated below. For warranty service, find the nearest Authorized Service Dealer in our dealer locator map at BRIGGSandSTRATTON. cOM , or by calling 1-800-233-3723 , or as listed in the `Yellow Pages'. Implied warranties, including those of merchantability and fitness for a particular purpose, are limited to one year from purchase, or to the extent permitted by law and all implied warranties are excluded. liability for incidental or consequential damages are excluded to the extent exclusion is permitted by law. Some states or countries do not allow limitations on how long an implied warranty lasts, and some states or countries do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state and country to country. Brand/Product Type Vanguardt Extended Life Seriest; I/C®; Intekt I/C®; Intekt Pro; Professional Seriest with Dura-Boret Cast Iron Sleeve; 850 Seriest with Dura-Boret Cast Iron Sleeve; Snow Series MAXt with Dura-Boret Cast Iron Sleeve All Other Briggs & Stratton Engines Consumer Use 2 years 2 years These are our standard warranty terms, but occasionally there may be additional warranty coverage that was not determined at time of publication. [. . . ] Any such part repaired or replaced under warranty will be warranted for the remainder of the period prior to the first scheduled replacement point for the part. Add on or modified parts that are not exempted by the Air Resources Board may not be used. The use of any non exempted add on or modified parts by the owner will be grounds for disallowing a warranty claim. The manufacturer will not be liable to warrant failures of warranted parts caused by the use of a non exempted add on or modified part. [. . . ]