User manual BRIGGS & STRATTON 9A400

[. . . ] For replacement parts or technical assistance, record below the engine model, type, and code numbers along with the date of purchase. These numbers are located on your engine (see the Features and Controls page). The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. MM/DD/YYYY Type: Code: Briggs & Stratton does not approve or authorize the use of these engines on 3-wheel All Terrain Vehicles (ATVs), motor bikes, fun/recreational go-karts, aircraft products, or vehicles intended for use in competitive events. [. . . ] After the engine starts, first disconnect the extension cord from the wall receptacle and then from the power cord receptacle (F). Note: If the engine does not start after three attempts, go to BRIGGSandSTRATTON. CAUTION: To extend the life of the starter, use short starting cycles (five seconds maximum). Check engine oil level Change engine oil Check muffler and muffler guard ** Not required unless engine performance problems are noted. However, if adjustments are required, see any Briggs & Stratton Authorized Dealer for service. CAUTION: The manufacturer of the equipment on which this engine is installed specifies the top speed at which the engine will be operated. After the engine stops, turn the fuel shut-off valve, if equipped, to the closed position. Turn off the equipment switch (either a rocker (A) or a key (B) switch). Note: In some areas, local law requires using a resistor spark plug to suppress ignition signals. If this engine was originally equipped with a resistor spark plug, use the same type for replacement. Install and maintain in working order a spark arrester before using equipment on forest-covered, grass-covered, brush-covered unimproved land. the state of California requires this (Section 4442 of the California Public Resources Code). 5% for each 1, 000 feet (300 meters) above sea level and 1% for each 10° F (5. N We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance and service of the engine and engine parts. Briggs & Stratton Corporation will repair or replace, free of charge, any part(s) of the engine that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. This warranty is effective for and is subject to the time periods and conditions stated below. For warranty service, find the nearest Authorized Service Dealer in our dealer locator map at BRIGGSandSTRATTON. cOM , or by calling 1-800-233-3723 , or as listed in the `Yellow Pagest'. Implied warranties, including those of merchantability and fitness for a particular purpose, are limited to one year from purchase, or to the extent permitted by law and all implied warranties are excluded. liability for incidental or consequential damages are excluded to the extent exclusion is permitted by law. Some states or countries do not allow limitations on how long an implied warranty lasts, and some states or countries do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. [. . . ] Warranted Parts Coverage under this warranty extends only to the parts listed below (the emissions control systems parts) to the extent these parts were present on the engine purchased. Fuel line, fuel line fittings, clamps · Air injection system or pulse valve failure of the Warranted Parts for a period of two years from the date the engine is delivered to a retail purchaser. No Charge Repair or replacement of any Warranted Part will be performed at no charge to the owner, including diagnostic labor which leads to the determination that a Warranted Part is defective, if the diagnostic work is performed at an Authorized B&S Service Dealer. Claims and Coverage Exclusions Warranty claims shall be filed in accordance with the provisions of the B&S Engine Warranty Policy. [. . . ]