User manual BRIGGS & STRATTON 589447

[. . . ] For replacement parts or technical assistance, record below the engine model, type, and code numbers along with the date of purchase. These numbers are located on your engine (see the Features and Controls page). Briggs & Stratton does not approve or authorize the use of these engines on 3-wheel All Terrain Vehicles (ATVs), motor bikes, fun/recreational go-karts, aircraft products, or vehicles intended for use in competitive events. Use of these engines in such applications could result in property damage, serious injury (including paralysis), or even death. [. . . ] The coolant level must be between the FULL and LOW, or ADD, marks on the coolant reservoir. If the coolant level is low, add a 50/50% coolant mixture of phosphate-free antifreeze and tap water to the reservoir. If the reservoir is dry, add coolant to both the reservoir and to the radiator. NOTICE: Before starting the engine, wipe the engine clean of any spilled oil. If required, add oil to bring oil level to the FULL mark (B) on the dipstick (Figure 2). Never start or run the engine with the air cleaner assembly or the air filter removed. If gasoline in the engine has not been treated with a fuel stabilizer, it must be drained into an approved container. If the air filter is excessively dirty, replace with a new air filter. Keep gasoline away from sparks, open flames, pilot lights, heat, and other ignition sources. Before replacing the fuel filter, drain the fuel tank or close the fuel shut-off valve. replacement parts must be the same and installed in the same position as the original parts. Before replacing the fuel filter (A, Figure 9), if equipped, drain the fuel tank or close the fuel shut-off valve. Use pliers to squeeze tabs (B) on the clamps (C), then slide the clamps away from the fuel filter. 5% for each 1, 000 feet (300 meters) above sea level and 1% for each 10° F (5. If tension is correct, the belt will move 3/8 -- 1/2 in (10 -- 12 mm) if 22 lbs (10 kg) of force is applied to the center of the belt. Position a pry bar (F) against the alternator (G) and the side of the engine block. N We recommend that you see any Briggs & Stratton 3/LC Authorized Dealer for all maintenance and service of the engine and engine parts. There is no need to drain gasoline from the engine if a fuel stabilizer is added according to instructions. Run the engine for 2 minutes to circulate the stabilizer throughout the fuel system. stale fuel causes acid and gum deposits to form in the fuel system or on essential carburetor parts. To keep fuel fresh, use Briggs & Stratton FRESH START® fuel stabilizer, available as a liquid additive or a drip concentrate cartridge. Store away from furnaces, stoves, water heaters or other appliances that have pilot lights or other ignition sources because they can ignite gasoline vapors. [. . . ] If any emission-related part on your engine is defective, the part will be repaired or replaced by B&S. B&S warrants to the ultimate purchaser and each subsequent purchaser that the off-road engine is: designed, built and equipped so as to conform with all applicable regulations; and free from defects in materials and workmanship that cause the failure of a warranted part to be identical in all material respects to that part as described in B&S's application for certification. The warranty period begins on the date the off-road engine is delivered to an ultimate purchaser or first placed into service. Subject to certain conditions and exclusions as stated below, the warranty on emission-related parts is as follows: 1. [. . . ]