User manual BRIGGS & STRATTON 440000

[. . . ] This manual contains safety information to make you aware of the hazards and risks associated with engines and how to avoid them. It also contains instructions for the proper use and care of the engine. Because Briggs & Stratton Corporation does not necessarily know what equipment this engine will power, it is important that you read and understand these instructions and the instructions for the equipment. For replacement parts or technical assistance, record below the engine model, type, and code numbers along with the date of purchase. [. . . ] When connecting the battery cables, first connect the positive (+) cable and then connect the negative (--) cable to the battery. When charging the battery, turn the ignition switch to the off position and disconnect the negative (--) battery cable from the battery. With engine off but still warm, disconnect the spark plug wire (A) and keep it away from the spark plug (Figure 6). Note: Any of the oil drain plugs shown below may be installed in the engine. Disconnect the oil drain hose (G, Figure 6) from the side of the engine. Carefully lower the quick oil drain (I) into an approved container (J). Before you install the new oil filter, lightly lubricate the oil filter gasket with fresh, clean oil. Install the oil filter by hand until the gasket contacts the oil filter adapter, then tighten the oil filter 1/2 to 3/4 turns. Some models are also equipped with a pre-cleaner that can be washed and reused. Install the filter into the engine base (D) and push down until the filter snaps in place. Keep fuel away from sparks, open flames, pilot lights, heat, and other ignition sources. Before replacing the fuel filter, drain the fuel tank or close the fuel shut-off valve. replacement parts must be the same and installed in the same position as the original parts. Before replacing the fuel filter (A, Figure 10), if equipped, drain the fuel tank or close the fuel shut-off valve. Use pliers to squeeze tabs (B) on the clamps (C), then slide the clamps away from the fuel filter. Dirt or debris can restrict air flow and cause the engine to overheat, resulting in poor performance and reduced engine life. Use a brush or dry cloth to remove debris from the finger guard/rotating screen (A). Keep the area around and behind the muffler free of any combustible debris (Figure 11). Store away from furnaces, stoves, water heaters or other appliances that have pilot lights or other ignition sources because they can ignite fuel vapors. stale fuel causes acid and gum deposits to form in the fuel system or on essential carburetor parts. To keep fuel fresh, use Briggs & Stratton FRESH START® fuel stabilizer, available as a liquid additive or a drip concentrate cartridge. There is no need to drain gasoline from the engine if a fuel stabilizer is added according to instructions. [. . . ] If you have any questions regarding your warranty rights and responsibilities, you should contact B&S at (414) 259-5262. Small off-road engines and large spark ignited engines less than or equal to 1. If any emissions-related part on your engine/equipment is defective, the part will be repaired or replaced by B&S. The following are specific provisions relative to your Emissions Control Warranty Coverage. [. . . ]